2008 Kawasaki Teryx 750 ATV Winch Mount

Yes, it will. If your 12” UFP brake rotor has 6 on 5-1/2 bolt pattern then the Kodiak 12" Rotor item #KR12S will work.

Yes! The Kodiak 10" Rotor #KR10S will fit on your UFP DB35 axle/brake setup. If you're needing a complete left and right side, the Kodiak Disc Brake Kit #K2HR35DS will work great as well. This kit includes 2…

According to EZ Loader, your trailer uses #LM67048 outer and #25580 inner bearings. The correct bearing kit is the #BK3-310. We have 3 options for disk brake kits for your trailer, with the difference being the finish. The 3 options are as follows:…

Thank you for the pictures! It looks like you've got some sort of square drop axle on your trailer and if you can't find an identifying sticker, I can still help you figure out what you've got so that you can make the swap to…

Yes. You can use double lip seals in place of single lip seals on your trailer hubs. The double-lip seals are much better at preventing grease leaks and seal blow outs. I have included a link to all of the double lip seals we carry.

It is plastic. The ComeUp UW-5000si Trailer Winch item #CU645010 is a light duty winch so it's housing and base are made of plastic. I attached a picture below that will show you the base. I've also linked an installation video that…

The Superwinch Terra Series ATV Winch #SW1125220 will fit your 2013 Yamaha Grizzly 550EPS, however, a custom ATV Winch Mount is required. I recommend using the Bulldog Winch Custom-Fit Steel ATV Winch Mount #BDW15132 with is confirmed for your…

We don't have an install video yet for the part #BDW15131, but I did attach a picture that shows the install instructions. It has a diagram that shows how it bolts to the Grizzly frame as well.

As you've discovered, a 2 inch receiver doesn't always measure exactly two inches by two inches. There is a manufacturing tolerance involved that allows the receiver to be a few hundredths of an inches larger or smaller than 2 inches,…

I went to the warehouse and measured the Bulldog Winch Custom-Fit Steel Winch Mount, part #BDW15151. The mount measures 8-inches tall, 6-1/4 inches wide, and 5 inches deep. The mounting holes on the bottom bracket are 2-3/4 inches center to center.…

The correct custom fit winch mount for a 2014 Polaris 570 Sportsman is the Bulldog Winch Custom-Fit Steel ATV Winch Mount part #BDW15151 which contains the industry standard winch mounting pattern so it will work just fine with the Badlands 3,500…

To verify the correct bearing kit for your 2006 Snowbear utility trailer you will need to measure your spindle diameter. The Bearing Kit #BK1-100 fits a straight spindle that is 1" diameter on the bearing surface. We also have the Bearing…