CargoSmart E-Track and X-Track System Tool Stabilizer Review Video

The Brophy Utility Shelf for E-Track - 18" Wide x 10" Deep - Black #ETLSB is not rated for a certain weight, so I wouldn't trust it for your 52 lbs when traveling. Instead I recommend using the CargoSmart Shelf Brackets for…

Yes, the Replacement Shark Fin Camera Mounting Bracket for Furrion Vision S RV Camera Systems #FRCBRKT-BL that you have on the back of your trailer will work with all of the Furrion cameras.

I went out to the warehouse and found that the mounting bracket for the Camco RV 360-Degree Awning Roller w/ Screen Door Slide #CAM42005 measures 3-1/16" high x 1-1/16" wide with mounting holes 7/8" apart on center. The…

Trailer jacks do sometimes fail even when they are being used under their capacity so while it's a bummer that yours did I wouldn't say you did anything wrong and maybe just had some bad luck with yours. For a replacement I really like the…

The Brophy 5 Slot Tool Rack for E-Track - Black Powder Coated Steel #ETTH is 24 inches long edge to edge. The inner diameter of each slot is 2 inches and the fittings that mount to your E-Track are 16 inches on center. I've attached a couple…

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck bed,…

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

For your Aluma 6810 HBT trailer, I recommend the Erickson Horizontal E-Track - Zinc Coated Steel - 2,000 lbs - 5' Long - Qty 1 #E19148 along with the E-Track Backing Plate - Zinc Plated Steel - 6" Long x 6" Wide #e96RR. This will save…

Installing the Etracks vertically in the way you described could work depending on how much weight the etracks would be supporting. I think the 2x6 idea would also work, but since you are concerned that would be too much weight you could split the…

Trailer stabilizer jacks like #TJSCHD-24 are not designed to be used to lift a trailer and hold it up for maintenance. Their purpose is to stabilize the trailer while it's parked and no more. What you're looking for is a jack to hold the…

Curt hitch ball #40038 has a 1 inch diameter shank. For Curt balls with 3/4 or 1 inch diameter shanks you would use wrench #C20001. The nut on that ball should use the 1-1/2 inch end of the wrench. You could also use a large crescent wrench if you…

There may be a solution for you though the Traffic Cone Holder for E-Track or Rack'em Spare Tire Holder #RA-26 does not have a specific weight rating for one of the brackets. There are a couple options for you to consider like the CargoSmart…