CE Smith Post-Style Guide-Ons Replacement Hardware Kit Review Video

Thanks for the picture and your patience! I did some research and made some phone calls, the correct replacement for your actuator is the Replacement Inner Member for Dexter DX7.5L Actuator - Single Axle w/ Disc - 2" Ball - 7,500 lbs item…

Thanks for the photos. It is clear you have a Titan brake actuator like the Brake Actuator with Manual Lockout - Bolt On - Drum - 2" Ball - 7,500 lbs #T63FR. It sounds like you need the Replacement Master Cylinder Assembly for Titan/UFP…

With 29-1/2 inch leaf springs like the #e46SR that you referenced the axle spacing you'll want to use with the hanger kit part #AP216-H238 would be 35-1/8 inches. You cannot use the over under kits we offer with slipper springs.

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

To determine the location for the front and rear hangers on your tandem axle trailer you will first need to make sure that you have the correct center point for your equalizer hanger. The center point of your equalizer hanger needs to be located…

Definitely looks like the springs are being overloaded and need to be replaced. You can use higher rated leaf springs but, the higher you go the stiffer the ride will be. Since we know the weight class with your axles the next step would be to…

I took the picture you sent in and put the dimensions you are looking for on them. I attached the dimensions to this page for you to check out as well.

We don't sell just the mounting bracket of the part #CE11452-A that you referenced but I added all of the dimensions to the picture you submitted.

The CE Smith Replacement Hardware for Post-Style Guide-Ons #CE11452-A consists of 3-1/2 x 5-inch long U-bolts and brackets that measure 4-5/8 x 3-7/8 inches, according to my contact at CE Smith. This hardware kit is intended for replacing parts from…

You will only need one set of the CE Smith Extra-Long U-Bolt Kit for Boat Trailer Guide-Ons - Pre-Galvanized Steel - 6" Tall, part #CE11416. Each side of the boat guide-on will take two u-bolts at the bracket. I have included a product…

The Replacement Mounting Hardware for CE Smith Roller-Style Guide-On part #CE11451-A is designed for use with 1-1/2" x 1-1/2" square tubing so it will work well with your guide-on posts.

Yes, the longer U-bolts of the #CE11416 will fit the #CE11451-A that you also referenced. The #CE11416 will give you U-bolts that are 1 inch longer than what's included with the #CE11451-A which are 5 inches long.