Replacement Ball for Reese Friction Sway-Control System Review Video

Thanks so much for the photos, and based on those, your 2018 Liberty Outdoors Little Guy Max travel trailer has a 3,500 lb Lippert square torsion axle, for which we do have the correct lift kit, which is the following: - Axle Riser Kit - Single…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

We currently offer two sway control hitch balls with a 1-1/4" diameter ball and 5/8" diameter shank, part #C40093 and part #RP58060. These are both sold in quantities of one but you can order multiple by changing the number in the…

The Replacement Head for Reese Weight Distribution System - Trunnion Bar #RP58167 is confirmed to go with your sway bars. There are two possible sway bar styles and that will impact the brackets needed. If you have the tapered bars that are straight…

The class III and greater hitch pins like part #PC3 are never going to be the weak point in a towing setup therefore they do not have a working load limit (WLL) or break strength rating. This is pretty standard across all trailer hitch pin…

I really wish I could say yes for sure, but Curt nor us has tested the ball #C17201 with an EAZ sway control unit so we don't know if it will work or not. Best solution we have would be an all new unit like the Reese part #83660 which would work…

In order to be able to use a dual cam sway control like a Reese Dual Cam High-Performance Sway Control #RP26002 you will need to have spring bars that are bent at the end of them. Check out the picture I attached that shows which bars will work and…

When choosing a weight distribution system, ideally the tongue weight of the trailer will fall right in the middle of the effective range of the system. Make sure that the tongue weight figure you use includes the fully loaded and ready to tow tongue…