Review of Gen-Y Hitch Sway Control Plate - GY33YR Video

Dexter recommends that you check the wires of the brake assemblies of your trailer to determine which magnet would be what you would need. If the wires are white you would need part #BP01-265 and if they are yellow part #BP01-301. However, aside…

To replace your GloBrite 126 marker lights you can use the #MC44RB. These lights are 2-wire incandescent lights measuring 4" long by 1-1/2" wide (same as your existing marker lights) and will work great for your trailer.

There is a weight distribution hitch option for your new 2021 Intech Flyer Discover with a completely covered A-frame. Instead of using a standard weight distribution hitch which has brackets that go around the frame you will need to use a weight…

Friction-style sway control mechanisms like #RP26005 and the items shown on the linked page DO NOT allow you to back up a trailer while the friction bar is engaged. It must be disconnected or at least have the tension released. Otherwise the…

I do have an option for you but if the weight distribution system is sway control compatible then there will be a tab on one or either side of the head which you can attach a friction sway control device to such as the Reese Friction Sway Control Kit…

Having 2 wheels will provide more surface area/contact with the ground. This could actually make it more difficult to maneuver compared to a single wheel. But two wheels are better than one when not on pavement. A single wheel tends to dig into dirt…

Adding suspension enhancement like Timbrens will help with sag and increase stability and ride quality. If your 2011 Toyota FJ Cruiser is a 4-wheel drive model, for the front you can use #TTOFTAC4A that you have referenced. There is no option for the…

As long as you are using the factory coil springs on your 2013 Toyota FJ Cruiser then the 2-1/2" lift kit you have in the rear will not be a problem. If you have a set of taller/stiffer aftermarket coil springs then you would need to test these…

We don't have a wider bracket than the #RP26005 for your ball mount so the best option we would have would be a new ball mount that has the bracket already attached like the Curt #D320 which has a drop of 2 inches since you aren't wanting to…

For the Gen-Y Glyder Shock Absorbing Ball Mount for 2" Hitches #325-GH-12001, there is unfortunately no way that you'd be able to use a weight distribution system. I do have another solution though. Sticking with a cushioned Gen-Y ball…

The Gen-Y Torsion Weight Distribution Shank #GY54FR will provide you with up to 6-1/2" of drop. You will need to measure the height of your truck receiver and the height of the trailer coupler when level to determine the correct amount of drop…

The Curt Rebellion XD Shock Absorbing Adjustable Ball Mount part #C83WR won't work with a weight distribution system due to the design of the adjustable shank but we do have a very similar option that will, the Gen-Y Torsion Weight Distribution…