Curt Adjustable 2-Ball Mount Review Video

A reducer like the Curt Reducer Sleeve 2-1/2" to 2" #C45405 will work with your current shank without any loss of capacity. Because there is another moving part, it may give you slightly more noise than using a 2-1/2 inch shank like #C17131…

The B&W Tow & Stow Pintle Hook with 2-5/16" Ball #BWTS10056 can tow up to 16,000lbs if you are using the pintle hook connection. The 2-5/16" hitch ball is limited to a 10,000lb trailer. If you are needing to tow 15,000lbs with a…

It sounds like you may have a loose wiring connection or a corrosion problem on the 7-way pin for the right turn/brake lights. This pin is the one at the 3-o-clock position as you're looking at the vehicle's 7-way; please refer to the linked…

The wrench size needed to install the Curt hitch ball part #C40086 that you referenced would be 1-13/16 inches. The torque required for tightening the but is 450 ft lbs...

I sure do, the nice folks at Bulletproof Hitch provided a dimensional diagram for their #HD256 adjustable ball mount. I'll post the diagram for you so you can check it out. I've also linked to a demonstration video that you might find…

On the Curt Adjustable Ball Mount part #C45902 the distance from the nearest hitch pin hole to gusset measures 3 inches and then from the furthest pin hole 4 inches.

The Curt Adjustable 2-Ball Mount #C79NR is going to be 12-1/4" from the center of the hitch pin hole to the center of the hitch ball. This has the 2-1/2" shank you are looking for and can be adjusted from 4-1/2" of rise to a…

The best option for a hitch lock with the Curt Adjustable 2-Ball Mount - 2-1/2" Hitch - 5-1/2" Drop, 4-1/2" Rise #C79NR is from InfiniteRule: - InfiniteRule Hitch Lock for 2-1/2" Hitches #34061072-D This is a stainless steel hitch…

To replace either of the hitch balls that come with the Curt Deep Drop Adjustable 2-Ball Mount #C49NR you need the Curt Dual Ball Attachment #C69NR. The individual hitch balls aren't replaceable so you have the get the platform piece, but you…

The Ford 2-1/2 inch trailer hitch on your 2005 F-350 does have a different corner radius then what 2-1/2 inch accessories have so there have been some fit issues. But the Curt products such as adjustable ball mount #C45902 didn't seem to be a…

Correct, there will need to be a small amount of wiggle room or play between the trailer coupler and hitch ball which is to allow the trailer to track and turn smoothly. If the connection point between the trailer coupler and hitch ball was too tight…

Based on how tight of clearance there is between the MultiPro tailgate and the rear hitch of the new Chevy trucks I can tell the Curt ball mount part #C43JR would not work with it. Best option is the B and W Tow and Stow part #BWTS20066BMP which was…