How to Replace Hitch Balls on the 15K Curt Deep Drop Adjustable 2-Ball Mount

Question

Question:

Can I replace an individual ball on the C49NR or do I have to get a whole new system?

asked by: Patrick

0

Expert Reply:

To replace either of the hitch balls that come with the Curt Deep Drop Adjustable 2-Ball Mount # C49NR you need the Curt Dual Ball Attachment # C69NR.

The individual hitch balls aren't replaceable so you have the get the platform piece, but you don't have to replace the entire ball mount. This platform section also comes with the pins to attach it to the shank so you can either have extras or use those as replacements as well.

expert reply by: Jon G

0

Answer 1

There is indeed a trailer hitch receiver fit for your 2024 Acura MDX, from Curt. I went ahead and verified this fit with the manufacturer for you, and the correct part is the following: - Curt Trailer Hitch Receiver #C22HR

view full answer...

Answer 2

You did not mention if your 2013 Chevy Silverado was a 1500, 2500, or 3500 so I can provide recommendations for all 3. For a 1500 I recommend Curt trailer hitch #14301. There is no drilling or trimming required for installation of this hitch. I…

view full answer...

Answer 3

The only internal pieces that are replaceable on a Diversi-Tech ball mount are the lock cores like what you mentioned with part #DTLBM02RK. Since this is the case you will need to replace the entire ball mount. I know this isn't the news…

view full answer...

Answer 4

Yes! To add both anti-rattle and a lock to the Blue Ox Adjustable Ball Mount with Clamshell for 2-1/2" Hitch #BLU79XR you need the XL Anti-Rattle Trailer Hitch Receiver Lock for 2-1/2" Hitches #SHP2040-XL. This has a block insert…

view full answer...

Answer 5

I spoke with Blue Ox who stated that the the inside channel of the Blue Ox Adjustable 2-Ball Mount #BLU75XR is approximately 2" wide. That being said, when you look at the pictures it's clearly about a 1/2" - 1"…

view full answer...

Answer 6

For the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" #C12172, there really isn't a solution other than to use a torque wrench. Without torqing the necessary bolts to the manufacturer specs, you void the warranty and…

view full answer...

Answer 7

Thanks for the picture! You're going to need the Equal-i-zer #EQ90-02-4200 which will replace your existing shank, and give your at least 2 more inches of drop which should get you just about perfectly level.

view full answer...

Answer 8

From the top of the shank to the bottom of the vertical section of the B&W Tow & Stow 2-Ball Mount #BWTS10040B measures 10". Then with the 2" hitch ball in the lowest position the 2-5/16" hitch ball will sit about 12"…

view full answer...

How to Replace Hitch Balls on the 15K Curt Deep Drop Adjustable 2-Ball Mount

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching