Trailer Hitch Installation - 2011 Ford F-150 - Curt Video

The Class lV trailer hitch that is designed to fit your 2011 F-150 is the Curt Hitch, part #C14002. This hitch has a 2 inch receiver opening. I went to the warehouse and measured the receiver material. It measures 1/4 inch thick. I measured a Class…

The owner's manual for the 2014 Ford F-150 only shows the gross combined weight rating which is the most that the truck and trailer can weigh together. So I checked the towing guide from Ford for the 2014 model year. Capacity is also dependent…

The Rhino-Rack Aero Bar Roof Rack for Camper Shells part #Y02-480B is a great option for fiberglass truck bed campers as it was made for this exact purpose. It can support up to 220 lbs but bear in mind this rating is tested independently of the…

Thank you for the photo; and while it is very likely, I don't have the exact dimensions of the Leer Hi/Lo camper shell on your 2004 Chevy Silverado with an 8 foot bed in order to say with certainty if you can use the Rhino-Rack roof rack you…

To convert the factory 4-Way flat trailer connector on the back of your 2010 Ford F-150, you will need Adapter 4 Pole to 7 Pole and 4 Pole, #37185. You will plug the factory 4-Way into the back of the adapter and hardwire the remaining 4 wires. The…

When installed on a 2010 Ford F150, the Draw-Tite #75691 would be partically concealed behind the bumper. The receiver tube is the main portion that'll be visible, along with the lower portion of the hitch crossbar. The linked installation video…

For your R-pod travel trailer, the biggest issue you will face is sway , so I recommend he Strait-Line Weight Distribution System w Sway Control - Round Bar - 10,000 lbs GTW, 600 lbs TW #RP66086 which is rated for total tongue weight between 200 and…

Since your 2012 Ford F-150 did not come with the factory to package, the blue wire for the electric brake output can be located at the manufacturers connector in the engine compartment on the drivers side near the firewall. You will notice a dark…

For the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K, the battery positive lead is connected to the red lead coming out of the back behind the DC fuse board. You may connect the refrigerator to…

Based on the sticker and weight ratings showing it would be a class III hitch. The difference between a class III like the Curt Trailer Hitch Receiver Item #C13903 and IV hitches like the Curt Trailer Hitch Receiver Item #C14002 is typically the…

The reason it is listed for trucks that have no factory hitch is due to the installation locations. If you said you are removing your hitch, you will be able to install a replacement hitch like part #C14002. To be able to install a replacement…

To replace the factory hitch on your 2010 Ford F-150 I recommend using the Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2" #C14002, which will give you a strong Class IV hitch with a 2" receiver. This will bolt on in the same spot…