Optronics Trailer License Plate Mount Bracket Installation Video

The correct trailer hub with 4 on 4" bolt pattern to use with the CE Smith Trailer Axle Beam part #CE33201GA is the Trailer Idler Hub Assembly part #AKIHUB-440-2-G-EZ-2K. The spring seats can then be moved in 1/4" on each side to…

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

You can mount trailer axles above or below the leaf springs. The difference is just the amount of ground clearance that the trailer would end up having. The biggest advantage with the spring below the axle (trailer will be lower) is that you would…

For your Optronics light part as2t216 we have found that the correct replacement lens is the part #AST60B. Normally the SAE number isn't a reliable way to find lens replacements as it's not a part number but we do know that this SAE…

Load range D has a capacity of 1,220 lbs at 65 psi, whereas load range E has a capacity of 1,520 lbs at 80 psi. Basically the only difference between the two is the weight capacity. With trailer tires you always want to have them inflated to their…

We do offer wheels and tire/wheel combinations in the 8-inch diameter and 5-on-4-1/2-inch bolt pattern you need, however none has as large a pilot hole as your original wheels' 3-1/4-inch size. All have a 2.8-inch pilot hole diameter and can be…

For your Saturn Inflatable boat the Malone EcoLight Sport Trailer part #MAL73FR is going to be your best option. It's appropriately sized for your Saturn and will work really well. Since your boat has a hull on it the bunks of the trailer will…

The dry weight of your 1993 Coleman Cedar Pop-Up camper is right at 1,000 lbs. You then have to add anything you've loaded into it to that number. Divide that in half and each tire should have a weight rating that is above that. The Kenda 5.70-8…

I believe your tires use the old Inch size rating that was used in the 1960s and 1970s. I believe it is an 8.55-14. You will need to measure your tire to be sure. The 14 would indicate that the tires are on 14 inch wheels. The width should be about…

I believe I have just the right license plate bracket for you. Take a look at the Trailer License Plate Mount Bracket, #LP15SB. It is just a little over 8 inches long at 8-7/16 inches. It is 4 inches tall. The center to center distance between the…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

The great thing about Bearing Buddy like part #BB1781 is that when you add grease to your system with the included fitting, it will move the spring-loaded piston outward and allow grease to seep around the edges to keep from damaging the seal. You…