Optronics LED Fendermount Trailer Clearance Light Installation Video

To replace your Atwood G6A-8E RV Water Heater I recommend the Furrion RV Tankless Water Heater - 16" x 18" Door #FR48SR. Since the G6A-8E is 12-5/8" H x 16-1/4" W x 17-5/8"D you'll need a slightly wider door than a…

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

The Laclede safety chains part #1483-535-04 are made in the USA and have a 5,400 lb capacity per chain. These also have a clevis style hook. Check out the review video I attached for more info as well.

I wasn't able to find any size info for the Glo Brite trailer light you have, but the part #STL72RB that you referenced is a 6-1/2 inch by 2-1/4 inch LED light assembly that can do stop/turn/tail functions that would work great on nearly every…

The Glo-Brite 9553 you have currently measures 6-1/2" x 2-1/4" x 2-1/4" so for an incandescent replacement option I recommend the Custer Trailer Tail Light - Submersible - Stop, Turn, Tail - Incandescent - Oval - Red Lens #G65R which…

You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading from…

If you already have brake drums you will not have to replace them unless they are damaged or became overheated and have discoloration on the inside armature surface where the magnet rides, grooves in the armature surface, or severe wear where the…

The closest LED replacement we have for the Trailer Clearance Light part 154A-R is the Thin Line LED Fender Clearance Light part #MCL65ARB. This light has both a red/amber lens, 10 diodes, and measures 3-15/16" long x 1-1/4" wide x…

You can use the pre-wired Fender Clearance Trailer Light #BA44FNL (left) and #BA44FNR (right) as turn signals. They come with a ground wire and power wire so you would just need to wire them to your turn signal power wires to give your fenders the…

That depends on what taillight assembly your trailer has whether or not an LED is available for it. Could you get me a picture of it by chance.

All you have to do is swap the incandescent bulbs with LED replacement assemblies. Your tow vehicle would not have a problem at all with this switch. In fact, it actually would thank you if it could since now the trailer wiring will draw a fraction…

LED lights draw considerably less amperage than incandescent lights. They also run much cooler. These 2 features are why LED lights last so long. The incandescent version of #STL8RB is #ST8RB and it draws 2.5 amps for the stop/turn signal functions…