Lippert SolidStep RV and Camper Steps Installation - 2016 Forest River Salem Hemisphere Lite Travel Video

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

Thank you for all of the info you gave. Based on that you'd want the trailer hub and drum part #AKHD-545-35-K that you referenced and then for brake assemblies to match you'd want the #AKEBRK-35-SA which is a self adjusting set for…

If you have retractable steps like the SolidStep Manual Fold-Down Steps #LC791573 and are adding the The Camco RV Adjustable Screen Door Deluxe #CAM43993, you would need 1/4"-3/8" of clearance at the bottom of the door to the…

It is possible to mount the springs on top of the axle which is called "flipping the axle". To accomplish this we normally recommend an over-under conversion however there is not one with square u-bolts available for your square…

If the screen door is not close to closing you need to trim the bottom of the screen door frame which I have also had to do. To do this, with the steps down, take tape and place a piece on each side, down on the threshold, at the edge of the step…

When the SolidStep part #LC791573 is installed on your RV there would be slight reduction in clearance above the threshold like you can see in the picture I attached. If it's already tight there it would become tighter. You may have to adjust…

I am sure we have a set of the SolidStep Manual Fold-Down Steps for a 2014 Grand Design Solitude 369RL but I will need measurements in order to confirm fit. The measurements required to confirm fit will be the inside width of the doorway as well as…

The brake pads on the 12" Dexter Electric Drum Brake Kit #23-180-181 are 3/16" thick. Dexter Axle recommends replacing them once they get down to 1/16" thick.

The Dexter Electric Trailer Brake Kit #23-180-181 (7,000 lbs.) and Dexter Electric Trailer Brake Kit #23-105-106 (6,000 lbs.) are both 12" x 2" brakes so they are interchangeable, but they have different axle ratings. The #23-180-181 is…

What you describe for your brakes after adjustment is not normal. You should have a slight drag on your brakes when spinning the hubs by hand when they are adjusted properly. There shouldn't be any difference when rotated in the opposite…

Yes, you should be concerned about your trailer brakes being connected on just one side, but before you reach out to a dealership let's double check first. Electric brakes, like the Dexter Axle #23-180-181, use magnets so when the brakes are…

Yes, you will need to use a new capture plate for the MORryde Pin Boxes with the Demco Hijacker 5th Wheel Hitch, the Demco Hijacker Autoslide Locking Plate for MOR/ryde Pin Boxes part #DM6025. The design of the skid plate on the pin box does not work…