Westin Diamondstep Rear Bumper with Installation Kit Review Video

I recommend installing our etrailer Trailer Hitch Receiver #e29AR on your 2008 Ford Ranger 4x4 with the 4.0L 6 cylinder engine. The frame mounted receiver may require the drilling of 2 additional holes as Ford did not drill these holes in every Ford…

Yes, it will. The etrailer Hitch item #e29AR will allow you to store a full sized spare tire beneath your 2005 Ford Ranger. This hitch is custom fit and bolts to your Ranger with included hardware.

I spoke with my contact at Curt and he stated that trailer hitch #13138 does fit the 2002 Ford Ranger Edge flare side. I have included a link to the installation details for you. If you plan on doing some towing, I recommend the etrailer Ball Mount…

If you want to install the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13182 on your 2016 Jeep Grand Cherokee, you will use M14 bolts that are grade 5 as well as compatible flat washers. That is the replacement for what is…

There are a few differences between the bumper we offer for your 1999 Chevrolet Silverado, part #32006 and part #63000 you referenced. I have attached a photo of the #32006 bumper you can check out. As you see it has a black textured step pad and the…

The Westin Fey bumper part #32012 that you referenced is the correct fit for your 2003 Dodge Dakota and is the correct color scheme as what you have now. It has the black section on top of the bumper and gray on the lower side sections just like your…

The Westin Fey Diamondstep Rear Bumper with installation kit #20002-92230 is rated for 800 pounds tongue weight and 8,000 pounds gross trailer weight. However, you will need to consult the truck owners manual to determine the towing capacity of your…

The B&W Heavy-Duty Trailer Hitch, part #BWHDRH25122 is designed to fit a 1995 GMC C/K Cab And Chassis pickup. This hitch will fit pickups with a 34 inch frame and will not work on trucks that have dual fuel tanks. I pulled one of these from our…

Based on the frame dimensions you listed for your 1977 Ford F-250 you actually have a cab and chassis model which has the narrower 34 inch wide frame. That means instead the hitch you need is the Curt part #13028 which is confirmed as a fit for your…

I went out to the warehouse and pulled Curt Class V Trailer Hitch #C15300 and took some measurements for you. From the front bolt hole to the rivet (center to center) is 1-5/16 inches. From the rivet to the rear bolt hole is 7-7/8 inches and the…

Yes, the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25122 referenced in your question will fit the 34 inch frame width on your 1977 Ford F-250. This was the common frame width on trucks during that time frame (along with most cab and chassis…

I checked with B&W and the Class V B&W Heavy-Duty Trailer Hitch #BWHDRH25122 is a confirmed fit for the 34 inch frame on your 1973 Ford F-350 that has a 10 inch step bumper. The only thing you may need to do is remove or modify the spare tire…