Review of TruRyde Trailer Spindles - Replacement EZ Lube Spindle - TRU27FR Video

Appreciate all that information, but unfortunately we do not have a 2,700 lb spindle, or one with those bearings and seal. The best I can offer is to go up to a 3,500 lb spindle, and you'd also need new hubs. What you can use is the following: -…

I would be happy to! To flat tow your 2021 Chevy Tahoe Premiere you will need the following parts: Tow Bar and Safety Chains - Roadmaster Sterling Tow Bar item #RM-576 Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item…

To get the best braking power for your boat trailer you would want to have disc brakes on both axles. If you happen to be limited to one axle then you would want the rear outfitted. With a 5,000lb boat you likely have two 3,500lb torsion axles. The…

The majority of brake line installations we do in our shop match the first method you have in the photo, labeled "Branch". We also prefer to use rubber hoses as they are easier to work with and there won't be an issue if you end up with…

The Lippert Lubed Straight Spindle with Brake Flange #TRU27FR has a stub diameter of 1-5/16" and is designed to fit a 2,500-lb axle. If your tow dolly has those specifications, this spindle will work on your axle. If you're not sure, check…

I do have an option for you but you can't run electric brakes on a 3,500 lb axle with 10" wheels as 10" brakes are too large and 7" brakes have different brake mounting flanges. That said, you can switch to surge brakes like the…

The EcoHitch #306-X7311 fits the standard 2014 Volkswagen Jetta as well as your TDI model so you're good to go! Attached is an installation video of this hitch on a 2016 Jetta for you to check out.

The Curt Upgraded Circuit Protected Powered Tail Light Converter - 4-Pole Flat Trailer Connector part #C56496 only draws power from the vehicle while a trailer is attached and the lights are activated. Therefore, you don't have to worry about it…

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

We don't carry that particular item, but it sounds like you have a 3500 lb axle. We carry some common sized trailer axles, but to determine if any of them would work for you I'll need the following information: -Axle hub face to hub face…

For replacement Dexter manual adjust brake assemblies to replace your 36-19 you would want the part #23-27 for the right hand side and part #23-26 for the left hand side. These are manual adjust 10 by 2-1/4 inch Dexter brake assemblies that would…

The only way to be sure the Trailer Hub Assembly, item #84545UC1-EZ, will fit on your spindle would be to take some measurements or get the bearing and seal part numbers to match up. Since it sounds like you cannot get to the bearings to record part…