TruRyde Trailer Bearings Races Seals Caps - Bearings - BK2-100 Review Video

Hey Kenny, yes the Dexter Equalizer kit part #K71-359-00 will work on your 2009 EZ Loader trailer. The dimensions match or in some cases are very close to matching. You wouldn't see any significant differences in geometry or ride height…

After speaking with EZ Loader what you have on your trailer is a 3,700 lb axle. From what they said the axle was upgraded even though your overall trailer capacity is 3,100 lbs. Although this uses the same #L44649 outer and #L68149 inner bearings,…

I have included a diagram below with the measurements of the #K71-359-00 equalizer. The shackle links included with this kit are 2-1/4" long when measured center hole to center hole. The kit is intended for use with 1-3/4" wide double eye…

Hey Glenn, The Hub Bearing Kit #BK2-100 comes with a cotter pin and a tang washer so that you can prevent either a standard nut or castle nut from backing off, depending on the type of spindle you have. Lippert easy-lube axles have a hole through…

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your…

I have tried to contact and have left many messages for EZ Loader to get the information on your bearings and seals. Unfortunately they haven't returned any call or email, so the best way to help you is to have you pull one of the hubs off your…

Yes, the Bearing Kit #BK2-100 does come with the tang washer and everything you see in the picture I attached. I attached a review video that shows everything included as well.

The Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles - 3,500 lb with #84 Spindle #BK2-100 falls under the etrailer brand. This kit includes the common bearings and seal for a standard 3,500 lb axle.

Yes, the Grease Seals part #RG06-050 are double lip seals that do have the spring that holds the seal against the spindle. I attached a video on bearing repacking and grease seal installation that you might find informative as well.

Although there are standard bearing and seal combinations, sometimes (especially on older trailers) the "correct" seal won't fit, as you have found out. The closest seal that we have to the 1.654 Inner Diameter (ID) that you measured is…

Not all bearings are created equal, but you would be hard-pressed to find one that is vastly superior than another. Whether it is TruRyde, Timken, or some other brand, if the bearings are properly maintained, used in the correct hub, and within the…