TruRyde Trailer Bearings Races Seals Caps - Caps - RG04-080 Review Video

The grease cap you need is part #21-42-1. The rubber plug that you would then need is the part #RG04-010. We are going to need to know the width of your current grease cap on the other trailer to pick out a Bearing Buddy. Or you can measure the inner…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

If the outside width of hanger #E4139 is 2-5/16 inches and the metal thickness is 3/16 of an inch then you would take 2-5/16 and subtract 3/16, and then subtract another 3/16, to get 1-15/16 inches. It is meant to be used with leaf springs that are…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The manufacturer of the TruRyde bearing and seals we carry like what come in the kit #BK2-100 is TRP International.

Not all bearings are created equal, but you would be hard-pressed to find one that is vastly superior than another. Whether it is TruRyde, Timken, or some other brand, if the bearings are properly maintained, used in the correct hub, and within the…

The best way to find the correct bearings, races, or seals for your trailer is to remove a wheel and hub and get the numbers off of the current components you have. If you are unable to fid the numbers on the bearings or seals or races, you can use a…

Since you have leaf springs that are most likely the 25-1/4 inch length unworn out the best leaf spring replacement would be the part #e34SR which is for 6k trailer axles. Since you wanted a slightly over rated spring this would work great.

You can measure either the outer diameter of the part of the dust cap that fits into the hub OR the inner diameter of the hub where the dust cap goes using calipers such as #PTW80157. Calipers are needed because the measurement has to be as accurate…

The * is for the models that come with an outer edge cut key. If you have a center cut key #BL7025287 will work great for your 2016 Chevrolet Colorado.

I was unable to find any information with the numbers on your axle, unfortunately. However, you can contact the manufacturer of the trailer and they should be able to tell you exactly which inner and outer bearings you have. If for some reason they…

You can use the other components you remove from your hubs. After you have removed the hub components you will want to inspect all of the parts and replace if you find any discoloration or signs of wear or damage such as a nick. On the race you can…