Review of RV Ride Control Trailer Leaf Spring Suspension - Alignment and Lift Kits - RR23QX Video

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the…

Thanks for all the pictures! It looks like your axles are already below your leaf springs so I recommend using the Correct Track Trailer Alignment and Lift Kit item #RR23QX you were looking at. This kit mounts to your spring hangers and moves the…

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower…

Bronze bushings like the #D014-077-00 do not require reaming when installing a shackle bolt into them. The splines in the bolt might make it a little tight but that is on purpose and does not require enlarging.

Thanks for reaching out about the Correct Track Trailer Alignment and Lift Kit #RR23QX, Mike! The instructions only mention adjusting the front axle before the rear axle, but I agree with you - the middle hanger that holds the equalizer will need…

Yes, all of the correct bolts and hardware are included with the MORryde Suspension Upgrade kit part #MR58ZR that you referenced.

I attached a link to a page that has install instructions for the Correct Track kit part #RR23QX that you referenced. I'd recommend the shackle bolt kit part #MR58ZR as it comes with the correct size bushings, bolts, and shackle straps.

The best way to lift your Jayco Eagle is called an over/under conversion kit, which moves your trailer's leaf springs to the top of your axle and lifts your trailer approximately the same amount as your axle's diameter plus the height of the…

Hello, sorry for any confusion. For determining the proper size Solera Slider your project requires you need to measure the total width of your slide room from the outside including the flange then add a minimum of 5" (2-1/2" each for the…

The recommended backing for the Wall Mount Adapter for Thule HideAway Awning part #TH307999 is plywood otherwise known as multiplex.

The Thule HideAway Awning part #TH490011 offers direct mount installation. Therefore, you'd need to attach the brackets directly to the wall of the trailer. If you have existing brackets, these would need to be removed. I have attached for you…

The previous generations of the Correct Track had some issues with brackets bending but the current generations like the single axle part #LC87120 and tandem axle #RR23QX have had all of that addressed and fixed.