Install Instructions for Correct Track Alignment Lift Kit RR23QX

Question

Question:

I am going to verify my spring hanger dimensions to ensure this fits. Is there instructions available that can be reviewed before ordering? What shackle bolts and bushings can i order to be used with this kit? Is there a shackle replacement available to be used with this kit?

asked by: Bill

0

Expert Reply:

I attached a link to a page that has install instructions for the Correct Track kit part # RR23QX that you referenced.

I'd recommend the shackle bolt kit part # MR58ZR as it comes with the correct size bushings, bolts, and shackle straps.

expert reply by: Jameson C

0

Answer 1

Congrats on the new truck! There are a couple of options to lift your 2020 Montana High County depending on if your axle's sit above or below the leaf springs. If your axles are already below your leaf springs the only option is the Correct…

view full answer...

Answer 2

Yes, the EquaFlex equalizer kit part #LC279688 is compatible with the Correct Track alignment kits like you have.

view full answer...

Answer 3

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower…

view full answer...

Answer 4

We have an EquaFlex wet bolt kit with the part #LC64FR which comes with new wet bolts, shackles, and nuts. The shackles are 3-1/8 inches like you mentioned wanting. Then for replacement bushings you'd want the part #LC32SV. These are…

view full answer...

Answer 5

You are right on with the equalizer kit you need for your 42 inch axle spacing, though the correct upgrade kit is going to be different than the #MR58ZR. What you will need is the following: - MORryde 14-3/4" Shock Absorbing Equalizers for…

view full answer...

Answer 6

Yes, it is possible. You will need to know the dimensions of your wet bolts, the inner and outer dimensions of the bushings, and the shackle strap dimensions, and the bolt hole diameter. Once you have this information you can find the correct part in…

view full answer...

Answer 7

I contacted the manufacturer regarding the measurements you were needing on the MORryde 14-3/4" Shock Absorbing Equalizers #MR34AR. I have included a diagram labeling some of these measurements. They did not provide a measurement for the…

view full answer...

Answer 8

Since you are going with a slightly bigger equalizer, the Equa-Flex Cushioned Equalizers - Double Eye Springs - Tandem Axle - 6K to 8K, part #LC279688, you will go with a smaller shackle strap. The MORryde Suspension Upgrade Kit for Tandem Axle…

view full answer...

Answer 9

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 10

There are a couple of things that you can do to get more ground clearance for your new trailer. First, if the leaf spring stack is attached under the axle then you could use an over/under conversion kit. If the trailer has a 2-3/8 inch diameter round…

view full answer...

Answer 11

Yes the MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR you referenced is close enough in dimension to what you have now that it will work as a replacement and will cushion the ride quality. It also will work fine with a Correct Track lift…

view full answer...

Answer 12

Yes. You can use the MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track - 2-1/4" Shackle Straps #MR58ZR without critically changing your trailer's setup. It is important to note that this particular kit is designed to…

view full answer...

Install Instructions for Correct Track Alignment Lift Kit RR23QX

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching