Performance Tool Wiring - Tools for Wiring - PTW2991 Review Video

When comparing the etrailer and Curt hitch options for the 2021 Ford Ranger, you will find that they are very similarly constructed, install in the same way and have very little differences in dimensions and rated towing capacities. It is possible to…

The best product we have for wiring third brake lights in a camper shell is the 3rd Brake Light Logic Module part #PP20-702. If you were to combine this with an in-bed wiring harness such as the Curt 5th Wheel/Gooseneck Custom Wiring Harness part…

There is a simple solution to get the isolated brake signal from your combined turn signal and brake wiring. You will simply use the Pacer Performance 3rd Brake Light Logic Module #PP20-702. The module filters out the unwanted turn signal. This will…

The Mini LED Identification Light Kit for Trailers Over 80" Wide #TN26MR actually get installed to your running light circuit. I know they are red, but they are designed to be used as a way to identify the width of the trailer. I recommend…

That's a very good question, so I reached out directly to the manufacturer, Optronics, about where the red wire goes on the Identification Light Kit #MCL22RK3B. They responded by saying you will connect the red wire to the stop/turn signal wire…

Yes you are correct in your assumption. On the Optronics Thinline LED #STL64RB, the Red wire is for turn signal, so this will go either the green or yellow wire on your trailer. The black wire is tail lights so this would go to the brown wire on your…

What you need to do is test the 7-Way connector both on your 2017 Ford F-350 and your trailer. Since your F-350 is new I doubt that it is on the vehicle side but you can use a circuit tester like part #PTW2991 and the attached picture of a vehicle…

The Identification Light Kit item #MCL22RK3B does not hook up to the blue brake wire on the 7 pin. The kit has a white wire for grounding, a black wire for the tail lights, and a red wire that connects to brake lights.

The grommet measures about 1/8" thick and the inner diameter is 1/4". The inner diameter of the front of the grommet where the light goes is 1". I have attached a diagram for your reference.

In regards to the Mini LED Identification Light Kit for Trailers part #OPT29FR, you will need to remove the grommet from the light and then push the light through the hole. Then, you can reinstall the grommet securing the light inside the hole.

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

The 3 LED Identification Light Kit for Trailers #MCL22RK3B have a 3 wire connection. This is because they are intended to be used as running lights and to light up brighter as brake lights. Because trailers use combined wiring, meaning the brake and…