Review of HappiJac Camper Tie-Downs - Front and Rear Tie-Downs - LC182860 Video

Yes, the Brophy Stake Pocket Mounted Camper Tie Downs #TDSF are a universal part that'll fit most full-size, non-dually pickup trucks with straight fenders and single-wall construction, so these'll work fine with your truck.

There are some trucks that the Brophy Clamp On Camper Tie-Downs, part #HSAB will not fit and your 2005 F-150 is among that list. We do have tie-downs that will fit your truck but there are a few things that are required to make sure you get a good…

Since the Brophy stake pocket mount tie downs, #TDSF, bolt into place, you would just need to un-bolt them from the truck to remove them for the season. It would be a good idea to then apply some sort of rust prevention where the hardware for the…

The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…

Our most economical camper tie downs are the Brophy Camper Hold Downs, #HSSF, and the Stake Pocket Tie Downs, #TDSF. These are universal tie downs designed to fit a number of trucks. I spoke with Brophy and they have not tested these tie downs on a…

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…

The "with/without board or step underneath truck bed" designation is referring to whether or not a step or nerf board runs underneath the truck bed. If you have these and they don't extend beyond the cab then you would choose the…

I checked the installation instructions for the Air Lift Ride Control Air Helper Springs #AL59530 that you referenced and there is drilling into the frame to attach the upper brackets of this kit onto your 2004 Toyota Tundra. I attached a picture…

We have just what you are looking for. The part #A10-1530DVP will plug in to the 110 receptacle of your generator and would give you a 30 amp female connector for the RV to plug into.

According to Lippert, the correct kit for your 2014 Ford F-150 is the: -HappiJac Truck-Mounted Camper Tie-Downs #LC182860. This kit includes 2 Front support braces, 2 Front brackets and anchors, 2 Rear brackets and anchors, and the mounting hardware…

I went out to the warehouse to take a look at the Brophy Camp On Camper Tie-Downs #HSAB referenced in your question. From the tie-down where it will clamp onto the inside of the bed rails to the outermost part of the unit, I measured a distance of…