Dexter Axle Trailer Hubs and Drums - Hub - 8-213-51UC1-EZ Review Video

The 008-445-15 is the Dexter Trailer Idler Hub #8-213-51 which is a galvanized hub for a 6,000 lb. axle with a #42 spindle. It has a 6 on 5-1/2" bolt pattern and 1/2" diameter x 2-1/4" long wheel studs fitting a wheel size…

We have pre-greased 6k trailer hubs with 6 on 5-1/2 inch bolt patterns like the etrailer part #AKIHUB-655-6-K but we do not have any that are galvanized. This would still work great in a marine application though.

Dexter now uses hubs rated for 6,000 lbs for their 5,200 lb axles (as they are discontinuing that specific capacity), but the 6k rated Dexter 8-213 hub will fit the spindle on your 5,200 lb axle as they use the same bearings. The correct galvanized…

The inner diameters of the LM67048 and 15123 both are the same (1.250 inches). That means that a hub with either bearing in the outer bearing would fit your spindle. The part #AKHD-655-6-EZ-K would fit your axle.

Since your spindle uses inner bearing #25580 and outer bearing #LM67048 the Dexter Trailer Idler Hub for 5,200-lb Axles - 6 on 5-1/2" #008-213-9B is going to be the correct replacement and includes new bearings, races, grease seal, and lug nuts.…

I reached out to my contact at Dexter and based on the part number you provided you have an older mobile home axle that has an 86-1/2" hub face to hub face measurement, and 75-1/2" spring center to spring center measurement. They were…

The Spindle Nut in the Redline #RG05-100 has a 1 inch inside diameter and a 14 thread per inch thread pitch. I am in the process of having this information added to the product description.

The #LM67048 and the #15123 both have the same inner diameter of 1.250 inches. So in theory they would both work on the same spindle. It sounds like you are thinking about using two different hubs on your trailer axle. As long as the hubs both use…

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…

The distance between the mounting surface of the wheel that touches the hub and the center line of the wheel, as shown below, is commonly referred to as the offset of a wheel. Most of the trailer wheels we offer, including the Castle Rock ST225/75R15…

You'll just need to know the wheel diameter, bolt pattern, and pilot hole to ensure a correct fit for your trailer. If you have a 6 bolt pattern it's most likely 6 on 5-1/2 and that would get you three wheel diameters; 15", 16", or…