Deka Wiring DW03240-1 Review Video

The Deka 16/4 Wiring #DW03240-1 you were checking out is actually annealed bunched copper wire strands.

I attached a picture for you to use as a guide for wiring in your trailer's 4-way wiring to a 7-way socket connector. The yellow wire is the left turn/stop circuit that you have out of the connector.

Yes, the center pin on trailer side wiring harness #H20046 is for reverse lights on the trailer. For this particular harness it is the yellow wire. But it will only work if the center pin is functional on your 2012 Toyota Tacoma. If you have the…

There are standard colors for trailer wiring, but not everyone will follow those guidelines and since your trailer is older it is likely that the colors are different. The best way to wire up your trailer with this 7-Way Molded Trailer Wire…

Unfortunately not all people will use the standard wiring colors when wiring up a trailer connector. This happens pretty frequently and the solution is to first determine what the wiring is and then wire by function according to the attached…

There isn't really a lot of differences between the Hopkins 7-Way RV Style Connector with Molded Cable - 8' Long - RV Standard #H20046 and Hopkins 7-Way Blade Style Connector with Molded Cable - 8' Long - Auto Standard #HM20041. Both are…

Your main problem is an insufficient ground for the trailer wiring. Try improving the connection of the main ground wire of the trailer wiring harness. Make sure it is attached to a clean metal surface. Or you can run all of the trailer wires back to…

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

An efficient Class III transmission cooler you can use on your 2011 Toyota Tacoma 4.0 V6 is the Derale plate-fin cooler #D13503 or the slightly smaller Derale #D13502. Both are designed for vehicles with late-model electronic overdrive transmissions.…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You would need a larger size heat shrink butt connector to fit two 14 gauge wires together in one end. The largest we have are for 10 to 12 gauge wire, #DW05745-10, and that size would likely work. There isn't a specific gauge wire used for the…