Curt Wiring - Trailer Connectors - C58145 Review Video

For a single diode to prevent current backfeed the part #RM-790 would be a great option.

Yes, you can use the factory trailer connector on your 2015 Nissan Titan to power the third brake light on your Leer camper shell. That said, they don't make a plug and play harness for this so you will need to do some wiring but no splicing into…

Yes, you will want to use a single function diode, like part #RM-690. You will need to wire it in between the breakaway battery and the trailer battery to stop the backfeeding from the battery to the breakaway system.

You can go to a larger 10 inch tire and wheel as long as you have the wheel well and trailer frame clearance available for the larger size. We typically recommend at least 3 inches of space between the top of the tire tread and the top of the wheel…

The main difference between a ST205/75-14 size tire like the Contender #AC14R45SM and a ST215/75-14 size tire like the Taskmaster Provider Item #TTWTR21514 is that the larger number is a slightly larger size. The 205 has a section width of 7.99"…

There is a difference between a 7-way round and and 7-way rv blade connector. If you take a look at the accompanying photo, which is from our linked article on trailer wiring you can see that the connector on the left has blade-style pins while the…

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

Yes, there is only one type of 7-way blade connector. I am attaching a help article about wiring that may be of interest to you.

To wire in the Curt 7-Way RV-Style Trailer Connector #C58145 you will need to match the wiring with their function and not rely on color. I have included an image that shows where the wiring goes on the connector below. Your Wesbar connector will…

You'll want to use 10 gauge wire like part #10-1-1 (sold by the foot) for the power and ground circuit of a 7-way accessory circuit. I attached a diagram that shows how 7-ways normally are wired for you to check out as well. The center pin could…

In order to use your reverse lights as utility lights you would have to have a separate 12 volt power wire running to the lights. You would need a switch and you would need diodes to prevent back feeding. You would need to run some wire from the 12…