Buyers Products Trailer Jack - A-Frame Jack - 3370091265 Review Video

The Tandem Axle Teardrop Fenders w/ Backing Plates #HP92VR are made of 16-gauge steel.

The mounting bolt pattern of the Buyers Products A-Frame Jack #3370091265 is 3" all the way around. The mounting holes are elongated though so if you have a slightly larger/smaller distance it should still work out.

I do have an option for you, but there is not an A-Frame trailer jack offered with a 1-7/8" or smaller outer tube diameter as 2-1/4" is the standard. What you will need to do is replace your bottom support plate with the #JSP-100…

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Currently the only way to replace the coupler mechanism on the A-Frame Trailer Coupler #CA-5400-B is to replace the entire coupler. If you are going to do this you should look at changing to the Demco 50-Degree A-Frame Trailer Coupler #12660-97SP as…

For your jack with part number #TJA-5000-B, the correct foot plate you'd need is the part #JF-99.

I went out to our warehouse for you and measured the Buyers Products A-Frame Jack w/ Support Foot part #3370091260. The distance from the bottom of the mounting plate to the bottom of the foot while fully retracted is 10-1/2" and 25-1/2"…

The diameter of the outer tube of the Buyers Products A-Frame Jack w/ Support Foot #3370091260 that you referenced is 2-1/4 inches.

The distance from the bottom of the mounting flange to the bottom of the outer tube on the Bulldog Round, A-Frame Jack part #BD155033 is 3-1/2". The mounting flange is 3/16" thick. I have attached a photo of these measurements for you as…

I recommend replacing your Atwood coupler with a Demco A-Frame Trailer Coupler #DM14791-97, as parts are virtually impossible to find for the older Atwood couplers. This will get you all new latch components that feature an EZ latch system. The…

I do have an option for you but coupler repair parts aren't universal so if any of the internal latching mechanisms are damaged or worn on your trailer coupler then chances are high it will need to be replaced for which we offer the A-Frame…