Review of Brophy Replacement Cable Camper Jack Tripod Base - 1106 Video

I measured the inside diameter of the Replacement Tripod Base for Brophy Cable Camper Jacks #1106 and found it was 2 inches. This base is a replacement for the Brophy Cable Camper Jacks - 57" Max Lift Height #CJ41 and 67" Max Lift Height…

I spoke to my contact at Brophy and he informed me that the diameter of the pole that would fit the Replacement Tripod part #1003 that you referenced will be 1-1/2 inches.

The Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks #TJD-7000S-GR you mention is designed to work with the TJD-5000S and TJD-7000S series jacks and will not work with your Rieco Titan Jack. However, since we don't…

You should not have a problem with the camper sliding out when you are using any of the Brophy Cable Camper Jacks. The jack is very stable because of the tripod base. That stability will make the jack very difficult to tip to the front or the back.…

We have Happijac camper tie downs that fit your 2006 Ford F-350 crew with the part numbers #LC182910-182971 but the ones you mentioned are not a fit.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…