Can Hitch Extender Be Used On 2007 Ford E-350 Van Towing A 2000 LB Boat

Question

Question:

I have a 2007 ford E 350 van can i use the 7 IN EXTENDER TO TOW A 2000 POUND BOAT? tHANKS

asked by: DAVID H

0

Expert Reply:

You will want to check out the hitch you have installed on your 2007 Ford E-350 Van to see what the towing weight capacity and tongue weight capacity your hitch is when considering a hitch adapter.

Using a hitch adapter like the Brophy Hitch Extender, part # HE12, will reduce the towing and tongue weight capacity of your hitch by 50 percent. If your hitch is rated for more than 4,000 lbs, you should be fine using this adapter, but I would check the tongue weight and weight of the fully-loaded boat to make sure. I have attached a photo of this extender that shows the dimensions you can check out.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

If you need 14 inches to clear your camper, you might be interested in the Curt #C45795. This hitch extender will give you 14 inches of clearance from your current pin hole location. Please note that using a hitch extender will decrease the weight…

view full answer...

Answer 2

The Hitch Extender For 2" Trailer Hitch Receiver 14" Long part #HE12 as with any hitch extender will reduce the towing weight capacity of the vehicle. The amount at which the weight capacity is reduced will be 1/3 of the capacity or 3,500…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

Answer 8

You are on the right track. The only way we have that will allow you to use the Thule T2 Pro Xtr Bike Platform Rack part #TH69TX with the 2.5" receiver tube opening on your truck would be with adapter. For this, I recommend the Brophy Hitch…

view full answer...

Answer 9

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 10

In order to both carry bikes and flat-tow a vehicle at the same time, you'd need to use an adapter on the motorhomes hitch, I recommend the Roadmaster Dual Hitch Receiver Adapter like part #RM-077-2 as it's designed for this exact purpose. In…

view full answer...

Answer 11

Congrats on the new camper! I have a solution but there unfortunately is not a manual to electric conversion kit for the HappiJac 4160 series jacks. The reason an electric conversion will not work for your 4160 is that they have a two piece…

view full answer...

Answer 12

The Draw-Tite Front Mount Trailer Hitch Receiver #65076 will fit your 2023 Ford F-350 dually. It features a bolt-on installation and has a 2" receiver. The hitch has a 9,000 lb line pull, 500 lb vertical load, and 5,000 lb gross trailer weight.…

view full answer...