Is the Curt Trunnion Style Weight Distribution System # 17302 Compatible with Surge Brakes

Question

Question:

Will this system work with surge controlled brakes - single axle boat trailer?

asked by: Rich H

0

Expert Reply:

Yes, the Curt Trunnion Style Weight Distribution System # 17302 that you referenced is compatible with surge brakes so it should work well on our single axle boat trailer with surge brakes.

I attached an FAQ on weight distribution systems for you to check out also.

expert reply by: Jameson C

0

Answer 1

As long as your Reese WD system part #RP66087 that you referenced has the correct tongue weight range for the tongue weight of your setup all you would need is the pole tongue adapter, part #RP58393. However, there is no way to use the dual cam sway…

view full answer...

Answer 2

II took a look at the weight capacity for your Honda Ridgeline and the loaded weight of your Keystone Springdale 179RD trailer. The dry weight is your trailer empty with no cargo inside whatsoever. Your trailer will be heavier once you get it loaded…

view full answer...

Answer 3

Yes. If you don't need the weight distribution bars attached to carry the trailer to storage, you can absolutely use just the WD hitch head and ball to tow the trailer. It will work just like a ball mount.

view full answer...

Answer 4

For your Magic Tilt Boat Trailer you will need a Blue Ox Pole Tongue Weight Distributing Hitch Adapter #BXW4023. This will bolt around the Pole frame with a width of 2-3/4" to 4-1/2" and height of 3" to 6". It will then allow you…

view full answer...

Answer 5

The Reese #RE34FR Weight Distribution kit can be used while backing your trailer, but if you need to make sharper turns that could possibly cause the trailer to jackknife, you'll want to remove the spring bars before backing the trailer. The…

view full answer...

Answer 6

What you need for your boat trailer is a pole tongue adapter like part #RP58393. This product is designed to work on trailers with straight tongues just like your boat trailer. I attached a picture of what it looks like installed. The best way to…

view full answer...

Answer 7

I spoke with my contact at Reese about pole tongue adapter #RP58393 and got some measurements for you. At the front it is 18.75 inches wide overall. At the back it is 22.98 inches wide overall. The frame height where the weight distribution brackets…

view full answer...

Answer 8

Based on the capacities you said your vehicle has I would recommend a weight distribution system strongly. I have spoken with one of my contacts at Reese, and have been told that weight distribution can be used with a folding trailer coupler like…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

Hey Dennis, we have a replacement 7-way plug with the part #A7WCB which would work great to replace your damaged one. I attached a diagram for 7-ways for you to check out as well.

view full answer...

Answer 11

Your camper is not too light for a weight distribution system and the Reese Pro Round Bar Weight Distribution item #RE34FR will work on your trailer. This system works with trailer's that have a tongue weight between 200 lbs and 600 lbs. The…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Is the Curt Trunnion Style Weight Distribution System # 17302 Compatible with Surge Brakes

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching