Reese Sway-Control Bracket Compatibility With The Convert-A-Ball Ball Mount Adapter

Question

Question:

Is the Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank - BA-1 compatible with the Reese Sway-Control Bracket for 2inch Ball Mounts - Class III and IV - RP26003?

asked by: David

0

Expert Reply:

Hey David,

Yes, the Reese Sway-Control Bracket for 2" Ball Mounts # RP26003 would be a compatible match with the Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank # BA-1. If you need the hitch ball as well for the sway-control bracket then you can use part # RP58060 for the ball and part # 37201001 for the pin. This bracket is 3/8" thick so you'll want to check if the shank of the hitch ball is long enough to accommodate the increased thickness.

expert reply by: Kevin C

0

BA-1 & RP26003 (1)
(click to enlarge)

BA-1 & RP26003 (2)
(click to enlarge)

Answer 1

To replace either of the hitch balls that come with the Curt Deep Drop Adjustable 2-Ball Mount #C49NR you need the Curt Dual Ball Attachment #C69NR. The individual hitch balls aren't replaceable so you have the get the platform piece, but you…

view full answer...

Answer 2

The Convert-A-Ball Ball Mount Adapter #BA-1 has holes spaced 1-1/4 inches apart on center and the holes are 3/4 inches in diameter. This is standard for most weight distribution system shanks so it will likely fit provided the holes on your shank are…

view full answer...

Answer 3

I pulled one of the Ball Mount Adapters, part #BA-1 from our warehouse and took a measurement for you. As the attached photo shows, the center-to-center measurement is 2-1/2 inches. With 3 inch spacing on your shank this will unfortunately not work…

view full answer...

Answer 4

Yes, the Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank #BA-1 will fit with your Curt shank. The Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank #BA-1 was designed to be used with the…

view full answer...

Answer 5

The distance between the mounting holes of the #RTB1 is 2 inches. The diameter is 5/8 inch.

view full answer...

Answer 6

I contacted our representative at Convert-A-Ball and the weight capacity of the ball mount adapter #BA-1 is 10,000 pounds and tongue weight capacity is 2,000 pounds. It bolts right onto your weigh distribution shank such as the Convert-A-Ball #AMAC1.…

view full answer...

Answer 7

Typically the distance from the center of the hitch pin hole on a 1-1/4 inch hitch to the face of the opening on the hitch measures 2 inches whereas on a 2 inch hitch the distance is 2-1/2 inches.

view full answer...