Replacement Swivel Jack For A 3" x 3" Mounting Bracket Hole Pattern

Question

Question:

Will this jack work with this setup? Im replacing a broken jack.

asked by: Chad

0

Expert Reply:

Yes, the Fulton Bolt-Thru Swivel Marine Jack # F1411300301 has a matching 3" x 3" bolt pattern to match up to your welded on mounting bracket.

expert reply by: Kevin C

0

Mounting Bracket
(click to enlarge)

Answer 1

The only trailer jack that will work with your existing mounting bracket and not contact the boat with a full rotation of the handle is the Fulton Bolt-Thru Swivel Marine Jack part #F1411300301. I understand this does not have the sharkskin coating…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The correct replacement for the Fulton Magnum Series Trailer Jack on your trailer is the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 if you have a bolt-thru mounting bracket or part #FTJ120W0301 if you have a snap-ring mounting bracket. I…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 5

I do have an option for you but the Shelby trailer jack mounting bracket that you have welded to your frame won't be able to be reused with any newer jack. The Shelby trailer jacks did use similar designs in regards to mounting like the…

view full answer...

Answer 6

I think you are on the right track. The Fulton Bolt-Thru Swivel Marine Jack you mentioned, part #F1411300301, is rated at 1500 lb. With the jack fully retracted, the distance from the bottom of the mounting bracket to the floor is 12.5". I…

view full answer...

Answer 7

The Demco Channel Tongue Trailer Coupler W/ EZ-Latch #DM13689-52 you were looking at uses 1/2" mounting hardware so you will need to pick up three 1/2" grade 8 bolts, six grade 8 washers, and three grade 8 lock nuts to secure this…

view full answer...

Answer 8

The best wheels for saltwater are going to be aluminum wheels because they do not rust. I would not recommend using a steel wheel like the #AM20315 you were looking at. It might hold up if you meticulously rinsed it with fresh water and made sure…

view full answer...

Answer 9

The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K is a direct replacement for a UFP H-1377.

view full answer...

Answer 10

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...