How Much Does the Curt Hitch C55HR for a 2024 Kia Forte Weigh?

Question

Question:

How much does this hitch weigh for a 2024 Kia Forte? Thank you

asked by: Alan

0

Expert Reply:

The Curt Hitch item # C55HR weighs 25 lbs. This hitch is custom fit for the 2024 Kia Forte's and installs with included hardware. This is a class I hitch with a 1-1/4" receiver. It has a 2,000 lbs towing capacity and a 200 lbs maximum tongue weight.

Please note that this hitch only fits the sedan models. It will not fit the GT's.

If you are planning on towing you will also need a wiring harness item # C54ER and the Draw-Tite Drawbar item # 3593 and then for hitch balls item # 19258 for a 2 inch ball or item # 19256 for a 1-7/8 inch ball.

expert reply by: Jerred H

0

Answer 1

The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part #C54ER, has a plug behind the sidewall of the driver-side. It is not in the trunk because it is behind the sidewall. Unfortunately, we do not have a video of this…

view full answer...

Answer 2

Yes, the Curt Trailer Hitch Receiver #C55HR will fit on your 2022 Kia Forte! This trailer hitch has a maximum towing capacity of 2,000-lbs, a maximum tongue weight of 200-lbs, and has a 1-1/4" x 1-1/4" class I hitch opening. You are also…

view full answer...

Answer 3

The best hitch for your 2023 Kia Forte Sedan is going to be the Draw-Tite Trailer Hitch item #DT83MR. This hitch is custom fit and bolts to your Kia with included hardware. This is a class I hitch, with a 1-1/4" receiver, that weighs 32 lbs. It…

view full answer...

Answer 4

The item you selected, Tow Ready Custom Fit Vehicle Wiring, part #118505, plugs in-line with the vehicles tail light connectors. You will need to access the wiring behind the tail light by removing the plastic trim pieces inside the vehicle. The…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

There sure is! You'd want to use the Draw-Tite #DT83MR, as the #24903 you'd looked at fits the previous generation vehicle and wouldn't fit your 2021 Forte. This being said, instead of the Draw-Tite #DT83MR which would be fully visible…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

Because the 8-14.5 tire that you've got sits on a 14.5" wheel, so you wouldn't be able to switch tire sizes with anything that we have available without also switching to a new wheel as well. If you've got a 6 on 5-1/2" bolt…

view full answer...

Answer 10

Yes. With the only hitch we carry for your 2022 Kia Forte, the Curt Hitch - 1-1/4" #C55HR, there is a bit of drilling required for installation. The instructions require you to drill out the rear mounting holes on the bottom of the frame rails.…

view full answer...

Answer 11

We have not yet had the opportunity to install the Curt Trailer Hitch Receiver #C55WR on a 2021 Mercedes-Benz GLA. This hitch does have a bolt-on installation, and the heat shield must be modified or trimmed. Although we do not yet have an…

view full answer...

Answer 12

Yes we do have the Curt Class III hitch part #C55WR that fits your 2021 Mercedes Benz GLA. This is a 2 inch hitch with a 3,500 lb trailer towing capacity.

view full answer...