Does Curt Hitch C14355 Fit 1999 Ford F-150 Flareside

Question

Question:

Will this hitch fit a 1999 ford F150 flareside truck. The first bolt closest to rear is 32 1/2inch on center. 14inch down from there its 34 1/4inch across. Hoping the oblong holes will help. Please advise Thank you

asked by: Joseph P

0

Expert Reply:

Yes, the Curt Trailer Hitch Receiver # C14355 is a fit for your 1999 Ford F-150 Flareside.

expert reply by: Kyle S

0

Answer 1

The towing capacity of your truck is going to depend on how the truck is equipped, such as the cab configuration and the rear end gear ratio. I can't provide you with a definite capacity without knowing the particulars of your vehicle, but I will…

view full answer...

Answer 2

The only differences in the 3 Curt Trailer Hitch Receivers #13355, #C13038 and #13359 for your 1999 Ford F-150 XL Flairside, is the construction and shape of the receiver cross tube and mounting plates. Of these 3 I would choose the Receiver #C13038.…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...