Replacement Right Rear Leg For Grond Control 3.0 on 5th Wheel Camper

Question

Question:

Hi I need to replace the right rear Lippert ground control 3.0 on my 2017 Jayco 339FLQS Eagle 5th Wheel Camper Can you confirm that the correct replacement part is: Replacement 24-1/2 Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System - LC344792 Thanks in advance

asked by: Dave E

1

Helpful Expert Reply:

Yes, the correct replacement right rear leg for the Ground Control 3.0 is the Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System # LC344792.

For whatever reason this leg doesn't come with the snapper pin to attach the foot pad so for that you'll need the Replacement 3/8" x 3" Snapper Pin for Lippert Ground Control 3.0 Electric Leveling System # LC225598.

expert reply by: Kyle S

1

Answer 1

I spoke with my contact at Lippert and he stated that the correct replacement right middle leg for your 6-Point system is the Lippert #LC344792. The rear legs for the 4-Point system are the same as the middle legs for your 6-Point system. I wish…

view full answer...

Answer 2

Yes, the Replacement Right Rear Leg #LC344792 is the correct unit to replace the rear passenger side jack on your Lippert Ground Control 3.0 System. I reached out to my contact at Lippert and he said there aren&#39;t any specific torque…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that&#39;s going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

For your 4 point Lippert Ground Control leveling system the correct wiring harness you need for the right/rear jack is the part #LC65ED and then for the correct replacement jack you would need the part #LC428493 and you&#39;d be set with…

view full answer...

Answer 6

So it sounds like it is the "passenger's" side of the trailer which would be the right side. That would mean rear leg #LC344792 is the correct replacement for you.

view full answer...

Answer 7

You should be fine as long as the rubber of the seal is intact and the metal is not deformed. There is a ridge in the hub that would prevent the seal from getting pressed in so far that the seal would interfere with the bearings. I confirmed this…

view full answer...

Answer 8

All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.

view full answer...

Answer 9

I went out to our warehouse to measure the Valterra EZ Valve Double Electric Waste Valves part #E84-8 for you. The wire lead on the actual valve is about 8-1/2" long whereas the wire lead on the switch is about 7' long for each…

view full answer...

Answer 10

Yes, you could use Valterra Bladex Waste Valve for RV Black Water Tank - 3" Hub to 3" Spigot Item #T40 with an automatic black water draining system such as Valterra EZ Valve Electric Waste Valve - 3" Hub x Hub x Bayonet -…

view full answer...