Can Valterra Bladex Waste Valve for RV Black Water Tanks be Used with Automatic Black Water Drain

Question

Question:

Will this Valve work on an automatic black water drain?

asked by: John M

0

Expert Reply:

Yes, you could use Valterra Bladex Waste Valve for RV Black Water Tank - 3" Hub to 3" Spigot Item # T40 with an automatic black water draining system such as Valterra EZ Valve Electric Waste Valve - 3" Hub x Hub x Bayonet - Double Rotating Flange # E84-8.

expert reply by: Michael H

0

Answer 1

The Furrion 2-in-1 Range Oven with Glass Cover #FR97KR is actually really close to the dimensions of your 21 inch Magic Chef so this would be an easy and great replacement solution that would fit perfectly.

view full answer...

Answer 2

I went out to our warehouse to measure the Valterra EZ Valve Double Electric Waste Valves part #E84-8 for you. The wire lead on the actual valve is about 8-1/2" long whereas the wire lead on the switch is about 7' long for each valve/switch.…

view full answer...

Answer 3

The wire gauge of the blue wire on the Hopkins Adapter 4 Pole to 5 Pole Trailer Wiring Adapter, part #47515, will be too small to be able to use as a 12 volt power source. You will need to use a 10 gauge wire on your truck to run a 12 volt power wire…

view full answer...

Answer 4

In order to disable the rain sensor on a Fan-tastic Vent #FV803350 without a remote you can hold the "up/down" button on the unit for 3 seconds as opposed to the remote. You should get a beep or a double beep to confirm the sensor shut off…

view full answer...

Answer 5

You will need to do some measuring to determine if the 10 Inch Electric Brake Assembly LH, item #AKEBRK-35L, is the correct assembly for your trailer. Measure the diameter of the mounted brake shoe, the width of the lining and the distance between…

view full answer...

Answer 6

Yes. The Dexter Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs #35545I-ST-89 will work with a trailer that has moved the leaf spring suspension to over the axles. Typically an axle has a slight bend in it because…

view full answer...

Answer 7

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 8

You can lubricate the valve by dumping some vegetable oil in and working the valve open and closed. If you can take off your valve without it being a huge hassle or have your valve is right at the opening I recommend using some water resistant…

view full answer...

Answer 9

The LaSalle Bristol RV Sewer Slip Hub with Flange - 3" #34466V13 you were looking at will work with the 3" ABS drain pipe on your RV. The hub side will bolt to your black water waste valve that you mentioned. You will also need the LaSalle…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Can Valterra Bladex Waste Valve for RV Black Water Tanks be Used with Automatic Black Water Drain

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching