2 inch Hitch Recommendation for 2013 Volvo XC90

Question

Question:

2013 volvo xc90 looking for class iii hitch it looks like your experts prefer the 75152 over the curt hitch. icant gind the listing

asked by: Steve

0

Expert Reply:

The Curt hitch part # 13559 is what we have found to be the best hitch that fits your 2013 Volvo XC90 and would be what I would recommend even if the Draw Tite you mentioned was still available. The Draw Tite happens to be unavailable at this time so we took it off our site.

In general we have found that the Curt hitches have the best quality control and a tougher finish.

expert reply by: Jameson C

0

Answer 1

view full answer...

Answer 2

For your 2008 Volvo XC90, the trailer hitch you want is actually the Curt Trailer Hitch Receiver #13559. This is the only Draw-Tite hitch confirmed to fit. For your wiring harness, you will want the T-One Vehicle Wiring Harness with 4-Pole Flat…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To add a hitch to your 2024 Toyota RAV4, I recommend the etrailer item #e23ZR. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a 4,000 lbs towing capacity, and a 600…

view full answer...

Answer 6

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 7

I verified directly with Curt for you that the correct 4-way wiring harness is following: - Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56370

view full answer...

Answer 8

That's right, the Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #118411 and the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C56045 are very similar for the 2005 Volvo XC90. They…

view full answer...

Answer 9

For a cargo carrier application the Draw Tite hitch part #75152 that you referenced would be the better choice. This has the higher 500 lb tongue weight capacity which is the correct figure to use for a cargo carrier. Weight distribution capacity is…

view full answer...

Answer 10

The etrailer Class III 2 Inch Hitch, part #e45KR, is a confirmed fit for your 2010 Volvo XC90. The Hopkins Endurance Multi-Tow 7-, 5- and 4-Way Flat Trailer Connector, part #HM48470, has a mounting bracket that can be bolted to your hitch. You can…

view full answer...

Answer 11

I was able to find some pictures to give you a pretty good idea of what the EcoHitch Hidden Trailer Hitch Receiver #306-X7311 looks like after installation and with a bike rack as well. I reached out to EcoHitch see if I could provide you with the…

view full answer...

Answer 12

We carry two trailer hitch receivers that fit your 2017 Volkswagen Jetta; a Draw-Tite, part #24926, and a Curt, part #C11474. With both hitches you can see the cross tube under the Jetta's rear bumper. I've attached pictures of each…

view full answer...