Will TorkLift PowerArmor Locking Battery Box # TLA7712R Protect Battery From Rain

Question

Question:

Is this box rainproof? I have a lithium battery outside that was stopped working because of the rain.

asked by: Remi

0

Expert Reply:

Yes, the TorkLift PowerArmor Locking Battery Box # TLA7712R that you referenced will protect your lithium battery from rain.

expert reply by: Jameson C

0

Answer 1

To install the TorkLift PowerArmor Locking Battery Box #TLA7700L you'll need to use the included self-tapping screws to mount the box to your trailer tongue. You can do this either directly to your frame, using the extension brackets if they are…

view full answer...

Answer 2

I do have a possible solution for you but unfortunately there aren't any battery boxes available that will hold two 12V batteries and fit within a 21" length and 8" width. The closest thing we have is the TorkLift PowerArmor Locking…

view full answer...

Answer 3

The base of the Torklift PowerArmor Battery Box is 31-1/8 inches long and the width is 8-7/8 inches.

view full answer...

Answer 4

The TorkLift PowerArmor Locking Battery Box for 6V and 12V Lithium Batteries #TLA7700L is designed for Lithium batteries. Lithium batteries are typically taller and more narrow so this battery box is designed to better support that size. The box…

view full answer...

Answer 5

I recommend the Fastway e2 Weight Distribution System part #FA92-00-0600 with 2" Hitch Ball part #A-90 for a Forest River Rockwood Geo Pro 15TB. In regards to using a weight distribution system, the rule of 10-15% for tongue load will still…

view full answer...

Answer 6

The TorkLift PowerArmor Locking Battery Box #TLA7708R that you referenced is designed to fit trailer frames just like what you have so it should work very well for you. This box is universal in design and can be installed virtually anywhere. The…

view full answer...

Answer 7

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The holes on the bottom of the TorkLift PowerArmor Locking Battery Box #TLA7700L aren't necessarily designed for mounting the box and are really there to allow moisture to escape and as access holes for wiring. According to the instructions there…

view full answer...

Answer 10

The dimensions of a Group 27 battery are 12 inches long by 6-5/8 inches wide by 9-3/16 inches tall so for a box that can carry two of them we have the TorkLift PowerArmor Locking Battery Box #TLA7708R which has dimensions of 26-3/4" long x…

view full answer...

Answer 11

The Torklift Battery Mounting Box part #TLA7708R or #TLA7700L that you referenced can mount to the brackets you have on your trailer as there are several holes on the bottom of the box that you can use to run bolts through to then attach to your…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...