Can the TorkLift PowerArmor Locking Battery Box # TLA7708R be Mounted to a Trailer Frame

Question

Question:

W.ill this box fit inside the standard angle iron that the plastic battery boxes fit into on the tongue of trailer. What is the weight of this box please

asked by: Stan

0

Expert Reply:

The TorkLift PowerArmor Locking Battery Box # TLA7708R that you referenced is designed to fit trailer frames just like what you have so it should work very well for you. This box is universal in design and can be installed virtually anywhere.

The weight of the box is 15 lbs.

expert reply by: Jameson C

0

Answer 1

There are no laws I am aware of that would prevent you from mounting the TorkLift PowerArmor Locking Battery Box on top of the trailer frame. It would not hurt to contact the local DMV or state highway patrol office to confirm. On a lot of trailers,…

view full answer...

Answer 2

I recommend the Fastway e2 Weight Distribution System part #FA92-00-0600 with 2" Hitch Ball part #A-90 for a Forest River Rockwood Geo Pro 15TB. In regards to using a weight distribution system, the rule of 10-15% for tongue load will still…

view full answer...

Answer 3

The TorkLift PowerArmor Locking Battery Box for 6V and 12V Lithium Batteries #TLA7700L is designed for Lithium batteries. Lithium batteries are typically taller and more narrow so this battery box is designed to better support that size. The box…

view full answer...

Answer 4

I looked up several pictures of 2020 Winnebago Micro Minnie 2108 FBS models and they all have easily enough room for the TorkLift PowerArmor Locking Battery Box #TLA7708R to fit as this was designed to fit campers just like the Micro Minnie. I…

view full answer...

Answer 5

Yes, the TorkLift PowerArmor Locking Battery Box #TLA7712R that you referenced will protect your lithium battery from rain.

view full answer...

Answer 6

As long as you have a 12 volt power source for the Rampage Radiant Backseat Heater #RA3501 you could install a thermostat switch on the power wire so that it would only come on in a certain temperature range.

view full answer...

Answer 7

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

view full answer...

Answer 8

You would need to reach out to Grand Design in order to determine the weight capacity of the rear bumper on your 2014 Grand Design Reflection 303rls. That being said, the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 does include support…

view full answer...

Answer 9

To install the TorkLift PowerArmor Locking Battery Box #TLA7700L you'll need to use the included self-tapping screws to mount the box to your trailer tongue. You can do this either directly to your frame, using the extension brackets if they are…

view full answer...

Answer 10

The dimensions of a Group 27 battery are 12 inches long by 6-5/8 inches wide by 9-3/16 inches tall so for a box that can carry two of them we have the TorkLift PowerArmor Locking Battery Box #TLA7708R which has dimensions of 26-3/4" long x…

view full answer...

Answer 11

The holes on the bottom of the TorkLift PowerArmor Locking Battery Box #TLA7700L aren't necessarily designed for mounting the box and are really there to allow moisture to escape and as access holes for wiring. According to the instructions there…

view full answer...

Answer 12

The Torklift Battery Mounting Box part #TLA7708R or #TLA7700L that you referenced can mount to the brackets you have on your trailer as there are several holes on the bottom of the box that you can use to run bolts through to then attach to your…

view full answer...