Is The Lippert Ground Control TT Compatible With A Lance 2565 Travel Trailer

Question

Question:

Is the Lippert auto leveling ok to put on a Lance 2565?

asked by: Bill N

0

Expert Reply:

Yes, the GVWR of a Lance 2565 travel trailer is around 7,300lbs and the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System # LC672136 is designed for use with trailers up to 10,000lbs.

I've attached a short video below where Dave will walk you through the installation process if you choose to put these on yourself.

expert reply by: Kevin C

0

Answer 1

Lippert #LC672136 is the best trailer leveling kit for your Lance Travel Trailer. They have an overall weight capacity of 10,000 pounds and are straight forward to install. I have attached a video walking you through the installation process.

view full answer...

Answer 2

Good question, and the Dexter Torflex lift kits are for square torsion axles, while the over/under kits are for standard round axles with double-eye springs. Your 2022 Lance 1995 travel trailer utilizes round 3,500 lb axles, so you will need the…

view full answer...

Answer 3

I have an option that will fit the bill but is missing one feature you are looking which is having the longer spindle for wider off-road tires. The Timbren Axle-less Suspension kits in the rating you need for your trailer do not come with the longer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 8

I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 10

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...