Can Curt 4-Way T-Connector Be Secured Near 2012 Ford Van Hitch Receiver

Question

Question:

Is there a way to run the wire down underneath the van and mount it to the hitch receiver so I don’t need to pull it out every time I use it?

asked by: Matthew S

0

Expert Reply:

There sure is a way to route the Curt T-Connector Vehicle Wiring Harness # C56020 on your 2012 Ford Van so that it stays installed next to your hitch receiver. I'm attaching an installation video of this wiring kit on a 2013 Ford Van that you can follow to accomplish this.

I also recommend picking up the mounting brackets # 18144 and # 18140 to secure the 4-Way next to your hitch receiver.

expert reply by: Jon G

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Both the Rhino-Rack Vortex Aero and Thule WingBar roof rack systems have very nice features and would work well for your 2014 Hyundai Santa Fe. Both systems are designed to work on vehicles that have the flush mounted rail system. As far as the…

view full answer...

Answer 4

It sounds like you are needing to install a 7-Way connector at the rear of your 2005 Ford E-150. If your Ford Van did not come with the factory tow package (with a 7-way connector), then there will not be a built in socket or harness under the…

view full answer...

Answer 5

The 4-way install harness part #C56020 that you referenced is a confirmed fit for your 2005 Ford E-150 van and would be one component needed to install your Curt Echo part #C79DR. You would also need the part #C26DR with 10 gauge wire part #10-1-1…

view full answer...

Answer 6

The Furrion Chill Replacement RV Air Conditioner for Dometic Brisk Setup - 15,000 Btu #FR42PV rooftop unit is fixed on the RV roof using 4 long bolts through the mounting frame from the interior of the RV ceiling. So you will need to be able to…

view full answer...

Answer 7

If there is no trailer connector on your 2006 ford E-250 van, I recommend the Curt Custom Fit Vehicle Wiring, part #C56020. This is a quick and easy installation on your van. This plugs directly into your existing wiring and requires no cutting or…

view full answer...

Answer 8

We actually have an FAQ article that explains exactly what you need to do to add a 7-Way to a 2008 Ford E-series van with a factory 4-Way wiring harness. I have linked it for you. There is no simple plug-in harness that will work but installation of…

view full answer...

Answer 9

A solenoid that has 3 terminals total such as #PK5231201 grounds through the mounting hardware so it must be attached to a clean and corrosion free bare metal surface (if not otherwise internally grounded). A 4 terminal solenoid such as #PK5230701…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...