Why Would Lippert Cross Shaft Landing Gear Bolts Keep Shearing

Question

Question:

What size bolts are used in this cross shaft? Mine broke on my camper from the previous owner and I keep going thru bolts that I replace them with

asked by: Austin

0

Expert Reply:

If you are going through bolts of the # LC334096 that would indicate you actually have a bad gear box which is putting too much stress on the bolts. To replace that you'd want the # LC276602. The bolts of the bar are not special so you can keep using ones you find locally and they would work just as good.

expert reply by: Jameson C

0

Answer 1

Yes, I checked with Lippert and for the Ground Control 2.0 the correct motor is the Tuson motor part #LC241795 that you referenced.

view full answer...

Answer 2

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

view full answer...

Answer 3

Slow landing gear is usually the result of the following issues: 1. low battery voltage 2. bad ground for the jack motor 3. lack of lubrication on the jack screws and pinion gear Your motor could be the culprit, but if it were me I would check the…

view full answer...

Answer 4

We have the same part number basically twice through two different vendors here that are the exact replacement motor you are looking for. The Lippert part #LC142178 and the Stromberg part #LG-142178. They are the exact same motors and if I were you I…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 8

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 9

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

Surge brakes use a hydraulic actuator to push fluid to the cylinder piston to activate the brake shoes on drum brakes or brake pads on disc brakes. This pressure should only be applied when weight is pushing against the hitch ball, so no pressure…

view full answer...

Answer 12

The Blue Ox systems cannot be moved back that far but we do have the perfect system for you. Take a look at the Reese SC weight distribution systems linked to the right (minus the ones that say Light Duty). These systems have narrow brackets that can…

view full answer...

Why Would Lippert Cross Shaft Landing Gear Bolts Keep Shearing

Products Referenced in This Question

Continue Researching