Does Curt Front Hitch # C31078 Fit 2022 Ford F-350 Dually

Question

Question:

Will this fit a 2022 F-350 Diesel Dully ? Ive not seen this question about a Dully. Thanks!

asked by: Eric B

0

Expert Reply:

Yes, the Curt Front Hitch part # C31078 that you referenced is a confirmed fit for the dually models of the 2022 Ford F-350 diesel.

expert reply by: Jameson C

0

Answer 1

No, you would not HAVE to factor in the weight difference between the Flex Air pin box #LC328492 and the factory pin box though you can if you want to and it would be more accurate. But a weight difference of around 100 pounds is not significant in…

view full answer...

Answer 2

The 1621 and 1621HD OEM pin box both have the same bolt pattern, so since your 5th wheel will max out at 14K, you can certainly use the 18K Trail Air Flex Air, part #LC328492. According to Lippert, when the Trail Air Flex Air is fully inflated, the…

view full answer...

Answer 3

I spoke with my contact at Lippert who said that either the heater is bad or the control box needs to be replaced on your Thomas Payne Momentum recliner. To test the heater unplug the red and black wires from the control box (located behind and under…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 9

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 10

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Does Curt Front Hitch # C31078 Fit 2022 Ford F-350 Dually

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching