Can 6" Wide Continuous Hinge - 8' Long be Cut Down to 7 Foot

Question

Question:

Can I cut it down to 7’ and not rune it?

asked by: Carlos

0

Expert Reply:

Yes, you can cut the 8 foot long hinge kit part # MA32VR down to 7 feet in length and it would work great.

expert reply by: Jameson C

0

Answer 1

Thank you for the pictures! I may have an option for you, but none of the hinges we offer have mounting brackets that are 5" tall.. The most likely option we have is the #PLR4040 which opens 270 degrees. The mounting bracket on the #PLR4040…

view full answer...

Answer 2

To properly measure your leaf springs you'll want to lift the trailer by the frame to take the weight off of the suspension and then measure from the center of the eyelet straight across the spring to the end of the slipper (pictured below). From…

view full answer...

Answer 3

The closest trailer tire size we offer to your 18.5x8.5x8 tire size would be a 215/60-8. This is essentially the same size as what you have. For a tire in this size you would want the part #AM1HP28. Check out the review video I attached as well.

view full answer...

Answer 4

The Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31952 referenced in your question has a maximum speed rating of 65 mph, which is the standard for most trailer tires unless otherwise listed. This radial tire has a maximum load of 1,360 pounds at…

view full answer...

Answer 5

Installing the Hinges on your Side-Door Bar Lock Assembly, item #305736, is pretty much up to you and the construction of your trailer. You will need to purchase appropriate hardware to install the Side-Door Bar Lock that you purchased. It is best if…

view full answer...

Answer 6

To install the Dometic water heater part #DMC74FR in place of your current Dometic setup what you need is the adapter part #DMC24FR and you'd be set.

view full answer...

Answer 7

With how long your current springs are, you will have replace the hangers for the springs to attach to. That being said, this does happen sometimes and it is not the end of the world. The 6-Leaf Double Eye Spring #e27SR will have a length of 26…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

To create barn doors out of your ramp door, you will need hinges and a latch. I suggest a latch/lock system like the Universal Cam-Door Lock for Enclosed Trailers - 1" Keeper, #383200. This will use a 3/4 inch diameter pipe that you'll have…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Can 6" Wide Continuous Hinge - 8' Long be Cut Down to 7 Foot

Product Page this Question was Asked From

Continue Researching