Replacement Leaf Springs for a Vintage Camper
Question:
Hello! I was wondering if this part would be a feasible replacement for the springs on my 1957 13foot canned ham camper trailer. The original leaf springs are 35inch eye to eye and 1 3/4inch wide with 10 leaves. I do not know the exact weight of this trailer, but I would say it is definitely below 4000 lbs. The axle is a square type with 3 1/2inch spindles, no brakes. Hopefully these pictures will help! If these are or arent the right springs for the job, could you direct me to what would be my best bet? Also along with the correct mounting hardware since I will most likely have to weld new mounts to my frame because of the shorter length. Thank you for any help and info!
asked by: Chris B
Helpful Expert Reply:
With how long your current springs are, you will have replace the hangers for the springs to attach to. That being said, this does happen sometimes and it is not the end of the world.
The 6-Leaf Double Eye Spring # e27SR will have a length of 26 inches from eye to eye, so you will also need the # APS2 hanger kit. This will cover both hangers on both sides, so you will need no other parts to get this system up and running.
Products Referenced in This Question
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front, 1-1/4" Rear
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Single Axle
- etrailer
more information >
Product Page this Question was Asked From
6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Trailer Leaf Springs
- Double Eye Springs
- 4500 lbs
- 1-3/4 Inch Wide
- 6 Leaf
- 26 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: leaf spring
- Shop: Kodiak Disc Brake Kit - 13" Rotor - 8 on 6-1/2 - Stainless Steel - 1/2" Bolts - 7,000 lbs
- Shop: Gooseneck Hitch
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Search Results: 56501
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Search Results: leaf springs
- Shop: Loadstar 4.80-12 Bias Trailer Tire with 12" Galvanized Wheel - 5 on 4-1/2 - Load Range C
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Brake Controller
- Search Results: drop leg
- Search Results: advent air conditioner
- Search Results: aps4
- Search Results: aps1
- Video: CE Smith Trailer Suspension - Leaf Spring Suspension - CE14017G Review
- Shop: Truck Bed Tailgate Assist
- Shop: Tailgate
- Q&A: Recommended Leaf Springs for Vintage Trailer
- Shop: Vehicle Tow Bar Brake System
- Q&A: How to Gain Ground Clearance for a Travel Trailer that Hits the Driveway When Entering or Leaving
- Q&A: Start Capacitor Solution for Dometic 15k BTU AC Unit
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Video: Review of etrailer by AxleTek Trailer Axles - 3,500 lbs Trailer Axle with Idler Hubs - e97YR
- Video: Bulldog Camper Jack - Landing Gear - BD182415 Review
- Q&A: Availability of Side Crank Trailer Jack with Removable Handle