Replacement Anode Rod Dimensions For a Suburban SW12DE Water Heater

Question

Question:

What length anode rod do I need for a 12 gallon model sw12de how water heater in my fifth wheel camper

asked by: Chuck

1

Helpful Expert Reply:

Your Suburban SW12DE water heater will use a Camco RV Water Heater Anode Rod # CAM11563. This anode is 9-1/2" long and threads on with a 3/4"-14 thread pitch. The anode rod is a sacrificial metal in this case aluminum so the anode will break down protecting the steel liner of your water heater tank.

expert reply by: Bud M

1

Answer 1

For your replacement tires to your Marathon ST235/80R16, I recommend the Taskmaster Provider ST235/85R16 Radial Trailer Tire - Load Range G #TTWPRG235R16. These tires are rated for speeds up to 81 mph and have a load capacity of 4,400 lbs at 110 psi.…

view full answer...

Answer 2

The correct Camco anode rod for your Suburban SW10DE water heater is part #CAM11563. You can confirm beforehand simply by comparing dimensions. This aluminum rod measures 3/4-inch diameter and 9-1/2-inches long. Aluminum anodes will tend not to cause…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 8

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Replacement Anode Rod Dimensions For a Suburban SW12DE Water Heater

Product Page this Question was Asked From

Continue Researching