Front Axle Springs For A 2002 Ford F-53 Without Striker Plates

Question

Question:

On most of the pictures ive seen on your site the front Timbrens contact a strike plate on top of the leaf spring. My RV just has the short spring on top of the spring stack but no plate for the bumper to contact with. It has 2 small rubber bumpers which contact the spring directly when compressed. Im concerned if the Timbren will work and align properly in this situation. ????????

asked by: Bill S

0

Expert Reply:

Though The Timbren Front Suspension Enhancement System # TFFF53B is confirmed to fit your 2002 Ford F-53 It would not work properly without the striker plate that is on top of the leaf spring. I recommend The Air Lift LoadLifter 5000 Air Helper Springs # AL57140. This kit installs between your vehicle's frame and its leaf springs.

The air springs have a 5,000 pound capacity and are constructed of 2-ply, fabric-reinforced rubber. They have an adjustable air pressure between 5 psi - 100 psi.

I attached an installation video link below.

expert reply by: Noah E

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

For your 2024 Ford F-53, I recommend checking out the Timbren Front Suspension Enhancement System #TFFF53B for the front, and the Timbren Rear Suspension Enhancement System #TFRF53A for the rear. These kits do not require drilling, will replace your…

view full answer...

Answer 8

For your 2023 Coachmen Pursuit 31BH you will need the Front SumoSprings Rebel Custom Helper Springs #SSF-170-40-2 and Rear SumoSprings Maxim Custom Helper Springs #SSR-184-40-1. If you were to select only one to install first I recommend the rear…

view full answer...

Answer 9

Believe me when I tell you, of all the questions we get, this is definitely NOT a stupid one, and to answer your question, both the Timbren Rear Suspension Enhancement System #TFRF53A and Timbren Front Suspension Enhancement System #TFFF53B will fit…

view full answer...

Answer 10

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...

Answer 11

When comparing the ride quality between the Timbren #TFFF53B and SumoSpring #SSF-172-40-2 I recommend going with the SumoSprings. Although Timbren is a very solid product, the SumoSprings have been proven to have more of a forgiving support over the…

view full answer...

Answer 12

The correct Timbren Rear Suspension Enhancement System for a 2021 Ram 1500 crew cab and double cab models is part #TDR1500DQ. The regular cab models use part #TDR1500DS.

view full answer...