Can Roadmaster D-Ring Adapter # RM-035-1 be Used with Demco Aluminator

Question

Question:

can the roadmaster RM-035-1 be used with a demco aluminator motorhome mounted tow bar? I think the shaft is the same size but need to confirm. will be towing jeep rubicon 2dr with smittybult ultra classic winch bumper with 1inch D ring tabs

asked by: Gary

0

Expert Reply:

We have had enough customers report back that the Roadmaster D-Ring Adapters like part # RM-035-1 do work with the Demco tow bars so it would work with your Aluminator.

expert reply by: Jameson C

0

Answer 1

We currently have two d-ring bumper adapters which are the Adapter for Jeep D-Ring Bumper Mounts part #RM-035 for 3/4" thick or part #RM-035-1 for 1" thick. These adapters are for factory bumpers with d-rings that are suited for flat…

view full answer...

Answer 2

The total width of the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars part #RM-035-1 is 2-1/8" which is measured from the outside of the ears.

view full answer...

Answer 3

Yes, the part #RM-035 that you referenced is available for purchase. I attached a link below that will allow you to add it to your cart. These Roadmaster adapters will adapt the Roadmaster tow bars to off-road bumpers. This will allow you to connect…

view full answer...

Answer 4

The Roadmaster Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars - 3/4" Thick #RM-035 will work on the 3/4" thick D-Ring mounts on your Rough Country bumper as long as the holes in them are 7/8" or 1"…

view full answer...

Answer 5

Yes, we have spoken with Demco and they have confirmed that the Roadmaster Adapter part #RM-035 that you referenced will work with your Demco Dominator tow bar part #DM9511008.

view full answer...

Answer 6

The dimensions of the bumper mount adapters for Jeep Wranglers #RM-035-1 which is 1 inch and #RM-035 which is 3/4 inch is referring to the thickness of the shackle mounts. They have adapter pins which allow them to fit 1 inch and 7/8 inch diameter…

view full answer...

Answer 7

I was able to find the diameter of the hole where the tow bar attaches to for the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars #RM-035-1. As you can see by the accompanying diagram, the holes are 1 inch in diameter. I…

view full answer...

Answer 8

There is an attachment available for your d-rings on your Jeep Wrangler. If you have 1 inch D-ring bumper mounts, then you will want the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars - 1" Thick #RM-035-1. If you…

view full answer...

Answer 9

I contacted Roadmaster on your behalf and they confirmed this bumper will be fit with the #RM-035 if the tab for the D-rings are 3/4" however you will need to confirm that the Barricade Adventure HD Bumper is rated for towing first. We also have…

view full answer...

Answer 10

The orange wire, see wiring diagram attached, is not used for the Roadmaster InvisiBrake Supplemental Braking System, RM-8700. Roadmaster added that wire when developing the braking system and found that it was not needed, so it is not used for…

view full answer...

Answer 11

There are definitely some products that can help you with that. Roadmaster recommends using a dry silicone spray lubricant like #RM-747, as grease or WD-40 can actually cause dirt and debris to stick, making the problem worse. Before lubricating,…

view full answer...

Answer 12

While we do not have the Blue Ox EZ Light Wiring Harness that you mentioned installing on your Jeep, I was able to locate the installation instructions for the kit. It looks like the converter box that you mentioned is designed to protect the wiring…

view full answer...