Diameter of Holes Tow Bar Attaches to on Adapter for Jeep D-Ring Bumper Mounts RM-035-1

Question

Question:

is there anyway to find out the diameter of tow bar shaft end that fits into this adapter on your site...RM-035-1.

asked by: Peter S

0

Expert Reply:

I was able to find the diameter of the hole where the tow bar attaches to for the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars # RM-035-1.

As you can see by the accompanying diagram, the holes are 1 inch in diameter.

I have added a link below to a video review for you to check out as well of the Adapter for Jeep D-Ring Bumper Mounts # RM-035-1.

expert reply by: Kyle S

0

Diameter of Tow Bar Attachment Hole
(click to enlarge)

Answer 1

I contacted Roadmaster on your behalf and they confirmed this bumper will be fit with the #RM-035 if the tab for the D-rings are 3/4" however you will need to confirm that the Barricade Adventure HD Bumper is rated for towing first. We also have…

view full answer...

Answer 2

The dimensions of the bumper mount adapters for Jeep Wranglers #RM-035-1 which is 1 inch and #RM-035 which is 3/4 inch is referring to the thickness of the shackle mounts. They have adapter pins which allow them to fit 1 inch and 7/8 inch diameter…

view full answer...

Answer 3

The total width of the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars part #RM-035-1 is 2-1/8" which is measured from the outside of the ears.

view full answer...

Answer 4

There is an attachment available for your d-rings on your Jeep Wrangler. If you have 1 inch D-ring bumper mounts, then you will want the Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars - 1" Thick #RM-035-1. If you…

view full answer...

Answer 5

Yes, we have spoken with Demco and they have confirmed that the Roadmaster Adapter part #RM-035 that you referenced will work with your Demco Dominator tow bar part #DM9511008.

view full answer...

Answer 6

We currently have two d-ring bumper adapters which are the Adapter for Jeep D-Ring Bumper Mounts part #RM-035 for 3/4" thick or part #RM-035-1 for 1" thick. These adapters are for factory bumpers with d-rings that are suited for flat…

view full answer...

Answer 7

We have had enough customers report back that the Roadmaster D-Ring Adapters like part #RM-035-1 do work with the Demco tow bars so it would work with your Aluminator.

view full answer...

Answer 8

Yes, the part #RM-035 that you referenced is available for purchase. I attached a link below that will allow you to add it to your cart. These Roadmaster adapters will adapt the Roadmaster tow bars to off-road bumpers. This will allow you to connect…

view full answer...

Answer 9

There are definitely some products that can help you with that. Roadmaster recommends using a dry silicone spray lubricant like #RM-747, as grease or WD-40 can actually cause dirt and debris to stick, making the problem worse. Before lubricating,…

view full answer...

Answer 10

The orange wire, see wiring diagram attached, is not used for the Roadmaster InvisiBrake Supplemental Braking System, RM-8700. Roadmaster added that wire when developing the braking system and found that it was not needed, so it is not used for…

view full answer...

Answer 11

While we do not have the Blue Ox EZ Light Wiring Harness that you mentioned installing on your Jeep, I was able to locate the installation instructions for the kit. It looks like the converter box that you mentioned is designed to protect the wiring…

view full answer...

Answer 12

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...