Finding The Correct Trailer Jack Caster Wheel For a Pace Outback DLX 5 X 8 Trailer

Question

Question:

i need a removable wheel for my trailer jack . My trailer model is 5x8 PACE OUTABCK DLX. Can you point me in the right direction ?

asked by: William P

0

Expert Reply:

To find the correct size for your tongue jack on your 5 X 8 Pace Outback DLX you will need to measure the diameter of the jack tube itself.

The Caster Wheel # UF49-954035 is designed to work with 2" jacks that have a lower jack tube that is 1-3/4" in diameter.

The Caster Wheel # JC-102 is designed to work with 2-1/4" jacks that have a lower jack tube that is 2" in diameter.

expert reply by: Bud M

0

Answer 1

Looks like you need a continuous hinge roof vent lid like the part #BV0554-01 based on what I can see in your picture can compared to the install pictures we have of this cover.

view full answer...

Answer 2

Thanks for sending in the picture of your roof vent hinge style. Because of that I know you need a metal hinge lid like the part #BV0554-01. I attached an install video for you to check out as well.

view full answer...

Answer 3

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Finding The Correct Trailer Jack Caster Wheel For a Pace Outback DLX 5 X 8 Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching