Replacement Control Unit for Kwikee Steps Control PN:909510000

Question

Question:

Have a 2005 Tiffin Open Road 35TSA class A RV with a bad step control and need a replacement. It is a Power Gear AT1800707 rev. OE with Warranty PN:909510000 Date Code: 08H20a info stamp on the current step control. Can you help me out on finding the correct step control for this RV? Thanks

asked by: Gary P

1

Helpful Expert Reply:

Thank you for all of that information, I was able to use the PN:909510000 (Kwikee part number) to locate the correct replacement control unit for your steps.

The Replacement Control Unit for Kwikee Electric RV Steps # LC379146 is the correct replacement. The # LC379146 is the Kwikee Part Number 909510000.

expert reply by: Scott S

1

Answer 1

Thank you for all of the information. Given the information you provided, the Replacement Control Unit for Kwikee Electric RV Steps #LC379146 is the correct replacement control for your steps.

view full answer...

Answer 2

The issue you are having your Kwikee Electric Steps could be attributed to a few different issues. The first issue could be that the override switch is not wired properly. I have attached for you below a photo that shows how the steps/switch should…

view full answer...

Answer 3

The back wire on the Replacement Control Unit for Kwikee Electric RV Steps part #LC379146 is for an under-step light which is only available on select models. If you do not have the under-step light then you would simply just not connect the wire.…

view full answer...

Answer 4

Yes the Lippert Components Kwikee 9510 Control #LC379146 is the same as Kwikee part 909510000. Since that is the part that Kwikee called out for your steps #LC379146 will fit.

view full answer...

Answer 5

In most cases I've seen, the control module is the likely suspect when the steps start functioning intermittently. The correct replacement module for your 909506000 is part #LC379606. We have confirmed this with Lippert on a few different…

view full answer...

Answer 6

The correct replacement control unit for your Kwikee 909510000 is the Replacement Control Unit for Kwikee Electric RV Steps #LC379146. This is a direct replacement for your current control unit as this is the same part.

view full answer...

Answer 7

The exact step you have is the Lippert Electric Tread Lite Step for RV #LC353543. Since the motor and linkage of the step set can't be accessed from the bottom you'll have to un-bolt the steps to access the motor area and see what the issue…

view full answer...

Answer 8

The 334850 part number you mentioned refers to the Replacement Control Switch #LC334850. This particular unit replaces the control switch assembly for certain Lippert Tread Lite RV Steps ( #LC353542, #LC353543, #LC353620, or #LC353621).

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...