Front Sway Bar that Fits 2021 Thor Outlaw Ford F-53 26k GVWR

Question

Question:

Hi! I’m looking for anti sway bars for my 2021 Thor outlaw V8 F 53 chassis. Can you tell me the part number for the front and back and how quickly could it arrive in French camp ca? Thank you!

asked by: Chris P

0

Expert Reply:

We have a front sway bar that fits your 2021 Thor Outlaw F-53 with a 26k GVWR with the part # RM-1139-148 but none of our rear sway bars fit the Thor Outlaw models like you have.

expert reply by: Jameson C

0

Answer 1

We typically do not publish torque numbers because manufacturers have been known to substitute hardware of different hardnesses from time to time but they do a great job of keeping the installation instructions updated to reflect any changes.…

view full answer...

Answer 2

You're on the money with what you need to improve the handling of your 2022 Fleetwood Bounder 33C motorhome. Big rigs like yours (which is on a Ford F53 chassis) can be very taxing due to how hard you have to work to keep it in line, so the best…

view full answer...

Answer 3

We have what you need. I recommend the Roadmaster Rear Anti-Sway Bar #RM-1139-149 for the rear suspension. For the front there is not a confirmed anti sway system yet but I do recommend the Timbren Front Suspension Enhancement System #TFFF53B. They…

view full answer...

Answer 4

The helper springs that fit your 2019 Fleetwood Bounder 35K motorhome (built on a Ford F-53 chassis) are the following: - Front Axle: SumoSprings Rebel Custom Helper Springs - Front Axle #SSF-170-40-2 - Rear Axle: SumoSprings Maxim Custom Helper…

view full answer...

Answer 5

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 6

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 7

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 8

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...

Answer 9

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 10

The Roadmaster #RM-1139-140 and #RM-1139-148 are both replacement anti-sway bars for a Ford F550 or F53 Class A motorhome chassis. Both bars are 1-3/4 inches in diameter. The #RM-1139-140 fits models with a GVWR of 22K-24K, and the #RM-1139-148 fits…

view full answer...

Answer 11

The Roadmaster Rear Anti-Sway Bar for Motorhomes #RM-1139-143 can use your factory u-bolts if they are long enough. If they are not, then Roadmaster recommends using the 7/8 inch diameter u-bolts that are longer (most likely the larger diameter due…

view full answer...

Answer 12

To flat tow your 2021 Jeep Wrangler Unlimited 4Xe Rubicon Hybrid you will need a tow bar, base plate, tow bar wiring kit, braking system, and safety cables. I have the following recommendations for you listed below: Tow Bar: Roadmaster Nighthawk All…

view full answer...