Replacement Bottom Jack Cover with Light Lens for a Lippert 3500-lb Electric Tongue Jack

Question

Question:

Good day, looking for a replacement light lens for the Lippert 3500-lb Electric Tongue Jack 1817941 thank you

asked by: Evan D

1

Helpful Expert Reply:

I have a solution for you but they do not offer just the lens for individual sale. You will need to use the Replacement Bottom Jack Cover with Light Lens for Lippert Electric A-Frame Trailer Jacks item # LC23UD. This will replace the lens and the bottom cover on the Lippert Electric Trailer Jack item # LC285318.

expert reply by: Jerred H

1

Answer 1

Lippert does not offer a replacement inner jack tube for their jack 1817941. When a jack is damaged in this way (which is more common than you want to know) it really is best to replace the entire jack for safety reasons. The outer tube on your jack…

view full answer...

Answer 2

I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does…

view full answer...

Answer 3

For your Lippert Electric Trailer Jack 1817941, the correct bottom jack cover is the Replacement Bottom Jack Cover with Light Lens for Lippert Electric A-Frame Trailer Jacks #LC23UD. If you ever should need the top cover as well, you can use the…

view full answer...

Answer 4

For a Lippert jack model 181794 a replacement manual crank nut is not available. I checked with my contact at Lippert to confirm. You will need to replace your jack with a complete new one, I am sorry to say. To help you select a new one I have…

view full answer...

Answer 5

I am not sure what your exact question is but the Lippert Power Gear Jack 181794 has been discontinued and there are no replacement parts available for this. Therefore, if you have an issue with yours then you will need to replace the entire jack and…

view full answer...

Answer 6

Yes, I confirmed with Lippert that the Replacement Top Cover for Lippert Components Electric Trailer Jack part #LC285160 will fit your Lippert 3,500 Lb Electric tongue Jack 1817941.

view full answer...

Answer 7

I have included the video and a link to the original answer page that also has the video you are looking for. There are 4 screws on the bottom of the bottom cover holding it to the top. And if you remove the cap on the very top of jack #LC285318 you…

view full answer...

Answer 8

For the Lippert powered a-frame jack part #LC285318 that you referenced the only way to get a replacement light lens is with the part #LC23UD which is a replacement bottom cover for the jack.

view full answer...

Answer 9

If the Lippert Electric Trailer Jack #LC285318 will not retract then the first thing you will want to do is make sure there is power reaching the jack and it is properly grounded. If you use a circuit tester at the power wire just before it enters…

view full answer...

Answer 10

It sounds like the switch in the jack is bad and should be replaced. Typically when an electric jack will go one direction but not the other its because the switch is broken. You might try checking all the fuses on the jack also. Since your trailer…

view full answer...

Answer 11

The Bottom Jack Cover #LC23UD has four screws in it that hold the top to it. You'll need to remove those screws first and take the top #LC285160 off. Once the top is off you can then dismantle the bottom cover from the jack and slide it off. Once…

view full answer...

Answer 12

To replace the lens on the Lippert Electric Trailer Jack with Footplate item #LC285318 you will have to purchase the Replacement Bottom Jack Cover with Light Lens item #LC23UD. This will save you some money and effort from not having to replace the…

view full answer...