Will I Be Able to Use the Thule Hullavator in the Channels of Rhino-Rack Vortex Aero Crossbars?

Question

Question:

What would the kit be with the longest bars?

asked by: John G

1

Helpful Expert Reply:

To address your question - yes. The top channels in the Vortex Aero Crossbars in the # Y02-490B are the same dimensions as the Thule channels like in the Thule WingBar Evo Crossbars # TH711420.

However, when it comes to finding the fit required for the Thule Hullavator # TH898 on a camper shell, it is a bit complicated. The reason why is because in order for the Hullavator to function in the "down" position, it requires at least 4 inches of crossbar clearance past the feet. In addition to the required four inches, it is also important that the tracks and crossbars have enough space/length in order for the tracks to mount to the edge of your camper shell to allow for that lowered position of the Hullavator.

Since the # Y02-490B includes crossbars that are 59 inches long, the top of your camper shell must not exceed 51 inches wide. The reason why is because if it measures more than that, there will not be enough overhang of the crossbars past the feet. In order to make sure your camper does not exceed these dimensions, I recommend measuring the width of the cap.

If you find that you need more crossbar length for your topper's roof, feel free to respond to this answer with the width of your truck cap's roof, and I will be happy to find you a solution.

expert reply by: Bob C

1

John G.

1/1/0001

What would the kit be with the longest bars?

Reply

Bob C.

1/24/2022

The setup with the absolute longest bars that can fit a track system on your camper includes the following parts: - Yakima JetStream Crossbars - Aluminum - Black - 70" Long # Y00427 - SkyLine Towers for Yakima Crossbars - Fixed Mounting Points, Flush Rails, and Track Systems # Y53TR - x2 of the Landing Pad 1 for Yakima SkyLine and Control Towers # Y00221 - Yakima 54" Tracks for Roof Racks # Y26RR With this system, your camper shell cannot exceed 62 inches in width in order to use the Hullavator # TH898. The Yakima tracks bolt directly to your camper shell.

Reply

Answer 1

The Yakima Replacement Anchor Plate Style-A, Part #Y8810074, comes as a set of 8 plates that measure 3/4-inch x 7/8-inch. The centered threaded hole measures 0.2 inches (or 5.1 millimeters) in diameter. Please refer to the photo provided. The Yakima…

view full answer...

Answer 2

I went out into our showroom and measured the dimensions of a set of discontinued Thule square load bars and found that they are 7/8 of an inch by 1-1/4 inches. This is identical to the Inno square bars like #INB137.

view full answer...

Answer 3

Thule roof racks can be installed in Yakima tracks like what you have. You'd need the fit kit part #THKIT3101 and the Podium feet like part #TH460R and the crossbars #TH711120 and you'd be set.

view full answer...

Answer 4

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 5

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 6

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 7

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 8

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 9

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 10

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 11

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 12

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Will I Be Able to Use the Thule Hullavator in the Channels of Rhino-Rack Vortex Aero Crossbars?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching